Instruction manual

NET/USB Function
Cannot access the network server
When NET is blinking, the AV receiver is not properly connected to the
home network.
Make sure your network server has been started up.
Make sure your network server is properly connected to the home
network.
Make sure your network server is correctly set.
Make sure that the router LAN side port is properly connected to the AV
receiver.
Make sure that the correct IP address is allocated in "7. Hardware Setup"
- "Network".
Playback stops while listening to music files on the network server
Make sure the network server is compatible with this unit.
When the PC is serving as the network server, try quitting any application
software other than the server software (Windows Media
®
Player 12 etc.).
If the PC is downloading or copying large files, the playback may be
interrupted.
Cannot access the Internet radio
Certain network service or contents available through the unit may not be
accessible in case the service provider terminates its service.
If a specific radio station is unavailable for listening, make sure the
registered URL is correct, or whether the format distributed from the radio
station is supported by the AV receiver.
When NET is blinking, the AV receiver is not properly connected to the
home network.
Make sure that your modem and router are properly connected, and
make sure they are both turned on.
Make sure that connecting to Internet from other components is possible.
If connecting is not possible, turn off all components connected to the
network, wait for a while, and then turn on the components again.
Make sure that the router LAN side port is properly connected to the AV
receiver.
Make sure that the correct IP address is allocated in "7. Hardware Setup"
- "Network".
Depending on ISP, setting the proxy server is necessary.
Make sure that the used router and/or modem is supported by your ISP.
Troubleshooting