Instruction manual

Others
Power consumption in standby mode
In the following cases, the power consumption in standby mode may
reach up to a maximum of 5 W:
– When “Network Standby” in "7. Hardware Setup" - "Network" is set to
"On".
– When “HDMI CEC (RIHD)” is set to “On”. (Depending on the TV
status, the AV receiver will enter normal standby mode.)
– The “HDMI Through” setting is set to other than “Off”.
– When “Wakeup via Bluetooth” in "7. Hardware Setup" - "Bluetooth" is
set to "On".
The power consumption in standby mode may be larger than the value
above while the MHL (Mobile High-definition Link) enabled mobile device
connected to the AUX INPUT HDMI/MHL jack is being charged.
The sound changes when I connect my headphones
When a listening mode other than Direct, Pure Audio, or Mono is
selected, connecting a headphone automatically selects Stereo.
The display does not work
The display is turned off when the Pure Audio listening mode is selected.
How do I change the language of a multiplex source
Select “Main” or “Sub” for “Multiplex Input Channel” in “3. Audio Adjust” -
"Multiplex/Mono".
The RI functions do not work
To use RI, you must make an RI connection and an analog audio (RCA)
connection between the component and AV receiver, even if they are
connected digitally.
While Zone 2/Zone 3 is selected, the RI functions do not work.
The functions System On/Auto Power On and Direct Change do not work
for components connected via RI
These functions do not work when Zone 2/Zone 3 is turned on.
When performing Automatic Speaker Setup, the measurement fails and
the message “Ambient noise is too high.” is displayed.
This can be caused by a malfunction in your speaker unit. Check if the
unit produces normal sounds.
Troubleshooting