Instruction manual

Default Value: 120Hz
Set the low-pass filter for LFE (low-frequency effect) signals in order to
pass lower frequency signals than the set value and thus cancel
unwanted noises. The low-pass filter will be effective only on sources
with LFE channel.
Select a value between "80Hz" to "120Hz".
"Off": Do not use this function
Subwoofer Phase
Default Value: 0°
Bass sound of the subwoofers may be insufficient depending on the
type of sound and the listening position. In that case, change the phase
of subwoofers. Set the phase value while listening to the sound so that
you can obtain your preferred bass sound.
"0°": The subwoofer is in normal phase.
"180°": The subwoofer is in reverse phase.
The setting cannot be changed if "Subwoofer" is set to "No".
Double Bass
Default Value: -----
Boost bass output by feeding bass sounds from the front left and right,
and center speakers to the subwoofer.
"On": Bass output will be boosted.
"Off(THX)": Bass output will not be boosted.
The setting will not automatically be configured even if you
performed the automatic speaker setup.
If "Subwoofer" is set to "No" or if "Front" is set to other than "Full
Band", the setting cannot be changed.
If you're using THX-certified speakers, we recommend the following
settings:
– Set a value "80Hz(THX)" in Crossover frequency.
– Set a value "80Hz(THX)" in LPF of LFE.
– Set a value "Off(THX)" in Double Bass.
Speaker Distance
Set the distance from each speaker to the listening position. Settings are
automatically configured if you use the automatic speaker setup.
Unit