Instruction manual

English English

POWER SUPPLY

This unit operates from a main supply of 230V ~ 50Hz. Connect the AC

power cord to the AC household main outlet. Ensure that the voltage

is as indicated on the rating plate on the rear of the unit.

Battery Back-up Power Failure Protection

This radio has a battery back up circuit that will keep the correct time

and alarm settings in the event of a temporary power interruption.

Install a 9-volt battery (type 6F 22/006P), not included, into the battery

compartment located on the bottom of the unit.

Note: We recommend an alkaline battery for longer usable life.

Change the battery every 9 to 12 months for best result and avoid

possible battery leakage.

If power is temporarily interrupted the display will blink and the radio

will not play. However, the battery back-up circuit will continue to

maintain the clock and alarm settings. When power is restored the clock

will display the correct time and alarm settings, and no adjustment is

necessary.

Note: If power is interrupted and there is no battery in the compartment

or the battery is exhausted. The time and alarm settings will be

lost. When power is restored the clock will begin to flash

indicating that the time and alarm settings must be corrected.

CLOCK

1. Set the ON/OFF/AUTO switch (1) to 'OFF' connect the Main Cord

to the power supply. The clock display will flash on and off

indicating a power interruption and that the display time is

incorrect.

2. To set the correct time, press the TIME SET button (6) and MINUTE

SET button (10), or HOUR SET button (9), together, until the correct

time is displayed.

3. Open the Clock Battery Compartment door and fit a 9V battery. The

purpose of this battery is to store the information relating to alarm

time. And to keep the clock functioning in the event of disconnection

from the mains supply or power interrruption. Should this occur. The

clock will continue to keep time, but will not display.

NOTE: THE LED DIGITAL CLOCK AND THE PROJECTION

CLOCK MUST BE SET SEPARATELY

TIME SETTING FOR PROJECTION

- Switch the projection switch to the 'ON' position.

- To preset the HOURS, press simultaneously the HOUR BUTTON

(21) and the TIME BUTTON (20), keep them depressed until the

hour digits to be preset are displayed.

- To preset the MINUTES, press simultaneously the MINUTE

BUTTON (22) and the TIME BUTTON (20). Keep them depressed