Operation Manual

MMI of CLR-2860UMP
___________________________________________________________________________________________________________
7
2.11 Cooking Timer Value Preset:
2.11.1 There are 6 preset Cooking timer
2.11.2 Press <Timer> once to enter the timer mode.
2.11.3 Press <UP> or <DOWN> to adjust the value (from 1 minute to 23hours and 59minute). press
<MEM> again to store it value.
2.11.4 Once <MEM> press, the ‘T’ goes flash. Press Preset + or preset - select location would be
save ‘T1 ~ T6 ’ goes solid, press <MEM> to confirm it.
2.11.5 Similar to < T 1>, repeat same step to select the desired cooking timer preset memory.
2.12 AOT (Automatically Off Timer):
2.12.1 When device stay in standby , press “AOT” button to tune on radio and AOT function will active
2.12.2 Once “AOT” was press, The current AOT value should show on display, press the key every time will change each 10
minutes, value of timer since 10 to 90 minutes maximum .
2.12.3 The function will automatically start if not any key press for 10 seconds
3 How to work of device
3.1 Using Cooking Timer:
3.1.1 Press <Timer> once to enter the timer mode.
3.1.2 Press <UP> or <DOWN> to adjust the value (from 1 minute to 23hours and 59minute) or press
<preset +> or <preset -> to recall the preset value, press <Timer> to start the cooking timer.
3.1.3 When the timer is running press <Timer> to pause the timer. To restart the timer press <Timer>
again.
3.1.4 When the timer remain 30 seconds, the remind tone “be” will sound, (it also sound at 30s，25s, 20s,
16s, 12s, 9s, 6s, 4s, 2s & 1s) the time reach to 00.00, the voice “be…be…be…be…be” will be heard
for one hour. Press <Timer> to terminate the timer and leave.
3.1.5 Press and hold <Timer> for 2 seconds to terminate the timer and leave, when the timer is running.
3.1.6 As the alarm becomes active, the cooking timer, if exists, is terminated immediately.
3.2 When SDA (Special Date Alert) Active:
3.2.1 When the date/month/(year) matches with the SDA which has been enable, alert becomes active.
3.2.2 As the SDA active, Sound of beep toggles at the Speaker for 10 minutes, Muted Radio even radio
ON & The “SDA” goes flash on LCD display
3.2.3 Press any key to start its corresponding function and the SDA will be terminate
3.2.4 When SDA is active, even key-lock has been switched on, press any key can terminate alarm.
3.3 When alarm is active:
3.3.1 When the real time clock matches with the alarm which has been enabled, alarm becomes active
3.3.2 As the alarm becomes active, the AOT if exists, is terminated immediately
3.3.3 If Beep sound alarm is selected,
a. Sound of beep toggles at the Speaker
b. Muted Radio even radio ON
c. The duration of alarm is 10 minutes
3.3.4 If Radio alarm is selected,
d. Radio On
e. the duration of the alarm is 60 minutes
3.3.5 Press any key to terminate the currently active alarm, even key-lock has been switched on .
3.4 Using the Radio:
3.4.1 start radio
 Press <Power> once to turn on the unit
 Press < Func/User > key to select Radio
 Press <Power> again to turn off the unit