Operation Manual
4
MMI of CLR-2860UMP
___________________________________________________________________________________________________________
When the automatic system setting had been terminate by user, the date and clock are
defaulted to
01.01.2012 ,0:00.
•
The alarms are defaulted to 0:00,
•
The radio is switched off
•
It then switches to auto-run mode
•
Default back light automatically set to dim from 23:00 to 05:59
2 How to setup the device:
When Radio is Off (Auto-Run Mode), Press <MODE|Stop> once go to different mode sequentially
Auto-run Mode with Clock display
1. Set the Clock
2. Set the Date
3. Set the SDA
4. Set update switch
5. Set
dimmer
work Mode
6. Set auto dimmer timer switch
7. Set start time of auto dimmer
8. set end time of auto dimmer
9.
Set Display mode (12/24 hour)
•
In clock display mode with Power OFF, the user can select alternative display for clock and date.
For details, please refer to the section of selecting alternative display.
•
In frequency display mode, the frequency of the radio station being received is displayed together
with the band goes solid in the display
•
Press <AL1> to review/set the alarm-1 when Power Off
•
Press <AL2> to review/set the alarm-2 when Power Off
• Only when the radio is ON, press <MEMORY>, <Preset +> or <Preset -> and then <MEMORY>
again to store the current station into memory.
•
Only when the Power ON, press <Vol.+> and Vol. -> to adjust speaker volume
•
When the radio is ON, press <AMS> to store preset memory automatically for the current user.
•
At every minute boundary, the real time clock is compared with the alarm setting if it has been
enabled. For details, please refer to the section of ‘When alarm is active’
Note: The Radio will active in background for time update at the 3.00 & 5.00 AM
2.1 How to set the clock:
2.1.1 Press <Mode|Stop > once when the unit stays in clock display mode
2.1.2 The clock goes flashing
2.1.3 The second keeps counting up once per second
2.1.4 Press <UP> to advance the clock by 1 minute
2.1.5 Press <Down> to move the clock back by 1 minute
2.1.6 Press and hold <UP> or <Down> to set the clock in fast mode of 10 minutes per step
2.1.7 Press <Mode|Stop > once to go to set the date.
2.1.8 Press other key to start its corresponding function.