Instruction manual

Play mode on LCD display
Repeat single track
& flashing
repeat all tracks
Repeat single folder
Random mode RAN
Off mode
z Repeat play
You can listen the desired track or whole disc repeat by this function.
z Random play
You can listen all the tracks in a random order by this function.
CD programming
Up to 20 tracks can be programmed for disc play in any order. Before use, be sure to press the “ stop ” button (8).
1. Set in CD mode & stop the CD playback.
2. Press the “ Mem/Clk-Adj ” button (6) and “ MEM ” will appear on LCD display (17).
3. Select a desired track by pressing skip up
or down button (23/10).
4. Press the “ Mem/Clk-Adj ” button (6) to store the track into memory.
5. Repeat steps 3 and 4 to enter additional tracks into the memory if necessary.
6. When all the desired tracks have been programmed, press “ Play/Pause
” button (20) to play the disc in assigned order.
7. Press “ Stop
” button (8) to stop playback, press Stop button again to clear all stored memory.
¾ The programming mode will automatically stop if no button is being pressed in a period of about 10 seconds after pressing
the “Mem/Clk-Adj ” button.
Playback of MP3 song via USB storage media or memory Card
The system is able to decode and playback all MP3 /WMA file which stored in the memory media with USB connecting port or
SD/MMC memory card.
1. Set the system at standby mode first or other function except SD or USB mode.
2. Plug-in the USB pen-drive with the face up & make sure it going into completely or insert the
memory card in the direction of the arrow as shown in the label on the up side of the memory
card slot. Insert straight without bending.
z Connecting the USB upside down or backwards could damage the audio system or the
storage media (USB thumb drive/SD/MMC card). Check to be sure the direction is
correct before connection.
3. Set function button (19) to “ ” SD/MMC card or “ ” USB mode.
4. The system will start reading the storage media automatically after connecting, and LCD display (17) will show the total
number of MP3/WMA files being detected.
5. Repeat the same playback procedure as playing CD/MP3 disc as above.
Remark
- The system can detect and read the file under MP3/WMA format only at USB/SD mode but not other music file format.
- If connect the system to MP3 player via the USB socket, due to variances in MP3 encoding format, some MP3
player may not be able to play via the USB socket. This is not a malfunction of the system.
- USB port does not support connection with USB extension cable and is not designed for communication with
computer directly
Removing of USB / memory card
To remove the USB / memory card, turn off the power or switch the function mode to either CD, Aux, Tape or Tuner first. For USB
port – un-plug it by pulling out the USB socket directly, for memory card – pull out the SD/MMC card straightly without bending.
Listing to tape
General operation
Stop / eject key Press to stop all deck operation. Press again to open the cassette door.
Fast Forward key Press to start rapid tape winding in either forward or reverse
& Fast Rewind
key direction. Press Stop keys when the cassette spools stop turning.
Play key Press to start playing tape.
Pause key Press to stop tape operation temporarily. Press again to resume play.
Record key Press together with play key to start tape recording.