User manual

6 Operating
Unpack and check carefully there is no transportation damage before using the unit.
Keep the equipment packaging. To fully protect the product against vibration, dust
and moisture during transportation or storage use the original packaging or your
own packaging material suitable for transport or storage, respectively.
Press and hold [S] and [3] simultaneously until the unit display switches.
ð
The display shows the set height in the corresponding unit.
1.
Hold down or to set a desired height from 61 cm (24 in) up to 126 cm
(50 in). The motor starts to work and moves the stand in the desired position.
ð
The display shows the set height (e.g. ‘090’ for the height of 90 cm).
2.
Release or to apply the setting.
ð
The motor stops.
3. Press [S] and then one of the buttons [1], [2], [3] or [4] to store the set height to
one of the number buttons.
4. Press one of the buttons [1], [2], [3] or [4] at any time to move the stand to the
stored height.
ð
The motor moves the stand automatically in the stored position.
1. Disconnect the device from the power supply and wait for 2 minutes.
2. Reconnect the device to the power supply.
3.
Press and hold for 5 seconds.
ð
The display shows ‘RST’ . The columns move in the lowest position (61 cm /
24 in).
Switching the unit centimeter/inch
Height setting and storing
Performing a reset
Operating
18
Multi Electric Stand
electrical height-adjustable stand