Owner`s manual
1
/
2
" Thread
To Controller
Pre-assembledAssembled
6
Figure 1
1. Install a ½" female threaded “Tee” in the field
wiring conduit approximately 12”(30 cm) from
the controller.
2. Feed the red, white, and blue wires of the
SmartPort
®
through the base of the “Tee” and
into the controller wiring compartment as shown
in Figure 1.
insTallinG THe RoaM ReMoTe WiRinG HaRness ...............
NOTE: Any extension of the wires
provided with the standard wiring
harness may result in an error
message on the controller display and
possible malfunction of the remote
due to radio interference. In some
situations, lengthening of the standard
harness may work fine, in others it
may not work at all (it is site specific).
In either case, it is recommended that
installations where the SmartPort
®
outlet will be located more than 5 ft
(1.5 m) from the controller that the
installation be done using the shielded
cable wiring harness (ROAM-SCWH)
to minimize the possible effects of
electrical noise.
NOTE: While the SmartPort
®
has a
protective cover to allow for outdoor
installation, the ROAM Receiver
should only be used on a temporary
basis, as the Receiver is not
designated for permanent outdoor
mounting.
3. Screw the SmartPort
®
housing into the “Tee”
(or other fitting) as shown in Figure 1.
4. Route wiring harness into controller housing.
Attach the red wire to the first AC screw slot.
Attach the white wire to the other AC screw slot,
and attach the blue wire to the R (or REM on
some controllers) as shown in Figure 2.