Owner`s manual

You have the ability to adjust the amount of time that

a station will run once it has been turned on by your

ROAM System. This does not affect the run time

programmed into your controller. There are 10 preset

run times from 1 minute to 90 minutes.

To change the Remote Activated Station Run Time

follow the steps below:

1. If the unit is off (no display), power the

transmitter up by pressing and holding the Mode

button

for 5 seconds. The transmitter will

first display the active station.

2. Press the Mode button

once and the Run

Time icon

displayed (default is 2 minutes).

If more than 10 seconds go by without a button

being pressed, the Transmitter will revert back to

displaying the active station.

3. Use the

and buttons to change the Run

Time to any of the 10 settings ranging from 1

to 90 minutes. Then do not touch any of the

buttons for 10 seconds and the display will

return back to the active station.

CHanGinG THe ReMoTe aCTiVaTed sTaTion Run TiMe ......