Owner`s manual

Both the ROAM Transmitter and Receiver have an

“address” that they use when communicating. If the

addresses do not match, the receiver will ignore the

transmission.

Your ROAM comes from the factory with both the

Transmitter and the Receiver address set to 1. You

may change the address to any value from 0 through

127 for added security. Note that if you change the

Transmitter address, the Receiver must “learn” the

new address as described in “Preparing the Receiver

for Use” section.

To change the Transmitter address follow the

steps below:

1. If the unit is off (no display), power the

Transmitter up by pressing and holding the Mode

button

for 5 seconds. The Transmitter will

display the active station.

CHanGinG THe TRansMiTTeR addRess ..................................

2. Press the Mode button until the Address Key

icon is displayed.

3. Use the

and buttons to change the

address to any value between 0 and 127. Then

do not touch any of the buttons for 10 seconds

and the display will return back to the active

station.