Owner`s manual

Your ROAM Transmitter comes from the factory with

the maximum station number set to 15. This means

that when you use the

and buttons to

change the station, you may change it to any number

between 1 and 240. However, if you only have a

6-station controller, you will never need to access

stations 7 through 9. Likewise, perhaps you will

own a Hunter controller like the ICC which can have

more than 9 stations. In this case you would want to

access the stations above 9.

Caution: If MAX station is set to 240, ROAM will

only work with the ACC controller. If you are using

an SRC, Pro-C, or ICC controller, make sure your

station count is set to 1 - 48.

The ROAM Transmitter allows you to set the

maximum station number as follows:

1. If the unit is off (no display), power the

transmitter up by pressing and holding the Mode

button

for 5 seconds. The Transmitter will

display the active station.

CHanGinG THe MaXiMuM sTaTion nuMbeR .........................

2. Press the Mode button until the Station Number

icon is

displayed.

3. Use the

and buttons to change the

maximum station number from 1 to 240. Then,

do not press any buttons for 10 seconds and the

display will return to the active station number.

4. You may now change the active setting to any

station in the new station range.