Owner`s manual

17
1. Before setting the receiver address, make sure
that the transmitter address is set to the address
you would like to use.
2. Plug the receiver into a SmartPort
®
connected
to a powered controller. When this is done, the
receiver will beep 4 times.
3. Once the receiver beeps 4 times, you have
approximately 10 seconds to send the new
address to the receiver. Press either the
or
button on your transmitter to connect.
4. The receiver will beep 4 additional times
indicating that it has learned the new transmitter
address and will respond only to that address
from this point on. If 10 seconds expire before
the
or button is pressed, the receiver will
beep once and retain its original address.
CHanGinG THe ReCeiVeR addRess ............................................