Owner`s manual

The ROAM System will allow you to remotely turn

on and off any station on your Hunter controller with

the press of a button. Once on, the station will run

for the run time you have designated in the remote.

To remotely activate a station or program follow the

steps below:

1. Plug the receiver into a SmartPort

that is

connected to a powered controller. The receiver

will beep 4 times followed by a 10-second pause

and a single beep.

2. If your transmitter is not on (no display), wake

it up by pressing and holding the MODE button

for 5 seconds. The Transmitter will display

the active station.

3. Use the

and buttons to display the

station or program you would like to start.

4. Press the

button to start the station or

program. The Transmitter will display the

Transmit icon

. If you are near the receiver,

you will hear it beep 2 times. This indicates that

the Receiver has received the command.

aCTiVaTinG a sTaTion WiTH THe RoaM ReMoTe

ConTRol sYsTeM .............................................................................

5. Press the button to turn off any station that is

on. The display will show the Transmit icon

and

receiver will beep again twice. The ROAM System

is designed to turn on one station at a time (unless

you activate a program). Therefore, turning a

station on while another station is operating will

cause the operating station to turn off.

NOTE: The ROAM remote can activate

any station on the controller whether

the controller dial is in the “SYSTEM

OFF”, “RUN” or “RUN/BYPASS

SENSOR” modes. If a sensor device

has been wired to the controller, the

ROAM remote will NOT override the

sensor for manual operation.