barroom User Manual Before operating this unit, please read the user manual completely and keep it. If the manual is lost, you can send email to request for an electronic manual.
ROAM | Range Hood READ AND SAVE THESE INSTRUCTIONS Dear users: Thank for your buying our range hood. Please accept our best regards. Please read this user manual carefully before installation and pictures in this manual only for your reference. If the picture isn’t accord with object, subject to object. We keep to right to update appearance, structure or products without notice.
ROAM | Range Hood /1 Danger Please turn off range hood immediately if pan got fire (range hood shall aggravate fire if it's working) and extinguish fire by effective action. Strict For example, cover flame by metal cover, turn off gas valve immediately Execution and remove inflammable things. Any abnormal, please lum off power, take off plug or cut off electric Strict source, and contact service. It's possible to cause electric shock or fire if Execution using range hood under abnormal situation.
ROAM | Range Hood /1 Warning There shall be adequate ventilation of the room when the range hood is Strict used at the same time as appliances booming gas or other fuels. Execution For Residential Use Only.And it's not allowed to exhaust dangerous or Strict explosive matter or air. It should be put under dry and ventilation Execution environment without dangerous air. The range hood and electric circuit must be installed by skilled and trained personnel with required qualification.
ROAM | Range Hood /1 Warning Strict Execution TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: a) Never leave surface units unattended at high settings. Boil overs cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium seeings. b) Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambe'). ¢} Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.
ROAM | Range Hood 1) Warning Do not use an extension cord. If the power supply cord is too short, have Strict a qualified electrician install an outlet near the appliance. Execution This appliance is not intended for use by persons (including children) with 0 reduced physical, sensory or mental capabilities, or lack of experience and ‘ knowledge, unless they have been given supervision or instruction strict on concerning use of the appliance by a person responsible for their safety.
ROAM | Range Hood 1 Notice Strict Accessible parts may become hot when used with cooking appliances. Execution DISPOSAL: Do not dispose this product as unsoiled municipal waste. Collection of such waste separately for special treatment is necessary. This product must not be disposed together with the domestic waste. This product has to be disposed at an authorized place for recycling of electrical and electronic appliances.
barroom Range Hood Belize 270mm} 10-5 Min Max mm} The size marked is for reference only. Packing List Please check the items in the container upon unpacking Standard Offerings 1 1 Hole size plate [] ; Range hood User Manual fee Sey Check valve Plastic expansion pips {tie) Gasket Plastic expansion pipe (Plasterboard) cup 4x80 wood strew 1 “ 12 Hitching leg ST4.
ROAM | Range Hood Mainframe panel accessories (optional) 2 ' pane! hanging foot 8 Mainframe panel self tapping screw 4 1 4 Plastic expansion pips (Plasterboard) Pra 4 4x80 wood screw Attached panel of the mainframe Decoration panel accessories (optional) ~~ 4 60112" decoration panel self tapping screw Installation A Warning 1.
ROAM | Range Hood Electric percussion Electric screwdriver Wrench Measuring tape Gloves Cross screwdriver drill Hammer Scissors Pencil Ast knife Cutting pliers Laval meter Beam detector Goggles Electric saw Notice @ Installation and circulate setting must be done by experienced professionals. Only a professionally trained person with an installation qualification can install the hood. Non-professionals are not allowed to install, dismantle and repair the hood.
ROAM | Range Hood Installation The range hood should be installed directly above the stove. In order to ensure the safety and the best effect of oil fume suction, it is suggested that the minimum distance between the top of the range hood and the cooker supporting surface on the stove should be (750mm) and the maximum should not be greater than 32-172" (825mm).
ROAM | Range Hood 8. Paste the opening sample plate with the text surface downwards on the bottom plies of the upper cabinet, and use the strict saw and the drill bit of diameter to open holes according to the requirements on the opening sample plate. Note: wear the goggles and gloves when opening the holes. 7. Lift up the range hood and hang the hanging foot on the boffin hanging hole, then push the range hood fo the wall, so that the back of the range hood is close to the wall. [a 8.
ROAM | Range Hood 10. Put the sealing gasket af the air outlet of the range hood, and fix the check valve with eight screws. Attach the duct to the check valve and seal with aluminum tape, make sure that the duct connection is sealed, and then plug tin. Check valve | screw , Check Duct 3 I valve seal i Aluminum I tape F J Note: Please straighten the flexible aluminum duct when mounting, fo avoid noise generals when the flexible aluminum duct is semi stretched, and cut off the excess parts with wire pliers.
barroom Range Hood 4.Determine the installation position of the hitching isg and the hitching leg fixed block: confirm the hitching leg position with the inside of tha upper cabinet plats bollix as the base and mark the drill holes.
ROAM | Range Hood 8.Put the sealing gasket at the air outlet of the range hood, and fix the check valve with eight ST4.2x18 screws. Attach the duct to the check valve and seal with aluminum tape, make sure that the duct connection is sealed. Note: Please straighten the flexible aluminum duct when mounting, to avoid noise generated when the flexible aluminum duct Is semi-stretched, and cut off the excess parts with wire pliers.
ROAM | Range Hood 12. After installation, the range hood must be kept horizontal. In the end, insert the oil cup and power it for test mm @installation without upper cabinet {10mm} comm) Nita: select the mainframe panel accessories if thees is no cabinet above the stove. 1. Open the container and take out the machine, and check the ff ems inside insignia the packing list. 2. Open the duct hole at the fop of the upper cabinet according to the opening position and size as shown in the picture below. 3.
ROAM | Range Hood 5. Fixed hanging fest 1} When the wall of the hanging machine is filch, use a dill bit of 3%" (8mm) in diameter fo drill 8 hole of in depth at the mark {not too big}, press bulged tubfuls} inch the hols.
ROAM | Range Hood 40. Tear off the protective film of the host panel and the host attached pans, insert the host attached anal into the host panel, and then fix the host panel on the lop of the range hood with 4 self-tapping screws. — Main machine = attached panel a Host pane! i T selfish-tapping \ 1. Taking the ceiling as a benchmark, mark the holes for the hanging legs of the main pans, so that the distance between the edges of the two hanging legs is slightly smaller than the width of the main panel. 12.
ROAM | Range Hood 14. After installation, the range hood must be kept horizontal. In the end, insert the oil cup and power it for fest run. ZEKE heed I | | s8x8 gs 75° 8" (10mm) mm). 85%e = sts User Manual Switchblade control panel Al spaced intelligent control Low 2 —— Lighting MAX Tum on the power and the buzzer will sound, indicating the power state. Power Crass the power bullion to enter the power on slate and the prows bunion icon lights up long.
ROAM | Range Hood in the power-on state: Press MAX button, MAX icon fishes, the fan starts {fo fry gear, the display shows "H", after 3 minutes, it automatically switches to strong gear, MAX icon goes oul, strong gear icon lights up, the display shows "3", i enters strong gear operation state. in the power-on state: ©The low key, the low vino lights up, the display shows "1" and the fan starts working in low mode.
ROAM | Range Hood In the power-on slate: D Press the high/turbo button, the high turbo icon lights up for a long time and enters strong operation. @Crass the highlighter key again, the highborn icon flashes, the fan snarls the burst gear, and automatically switches to the strong gear after 3 minutes, at which time the icon lights up fora long time and enters the strong running slate. harass this Burton repeatedly fo cycle the fan between "strong and fy".
barroom | Removal of Components Range Hood A Warning 1. As a general rule, the hood body does not need io remove, and removal shall be done by professional maintainers. Nonprofessionals are forbidden to remove, install and repair the hood. 2. Before cleaning, installation or maintenance for the range hood, cut off the power supply te avoid electric shock. Note: The installation procedures of the following components are in reverse with the removal.
ROAM | Range Hood Filer disassembly 4. Long press the cleaning button to open the air deflector. 2. Hold the two magnetic clasps on the filter with both hands, slightly exert force outwards to mask the filter no longer ke absorbed, then lift the filter according to the direction of the arrow to make it separated from the neck, and finally pull out the filter to clean the filter. Merck Magnetic clasp Hood disassembly 1. Take down the lamp according io the lamp disassembly steps; 2.
barroom | Circuit diagram Electrical Connection Diagram: Range Hood white W| \ blue ( Control circuit \ derv M J black nau Bugger L 120V~ N— 2 irreligion E Troubleshooting of General falls Serial Fault Solution number ad Cause Mo response after pressing any icon . ; The power plug is not connected . 1 (8.9. the.
