User Manual

User Manual
9
Plug in and 3 ticks from the buzzer will indicate qualified installation. Now the hood is in standby.
Lighting
Low
Power
Switch Control Panel
Turbo/High
Maintenance
Press Power button, the icon is on and the hood is powered on waiting for operation
directions. When the Power icon is lit up and only the spotlight is on, press the power
button gently and the spotlight will be turned off directly; if the fan is working under
power-on mode, press the Power button, the power icon will flash and the hood will
enter delayed working state, and all working state will be disabled after 1min (under delayed
working state, all Turbo/High , Low and Lighting buttons will be disabled);When the
Power button and all functions are shut down.
“ ”
“ ”
“ ”
“ ” “ ” “ ”
“ ”
Under power-on mode, press “Turbo/High” button to enable the turbo function. When the
icon twinkles, press the button again to switch to high level. In case no operation is taken
after enabling the turbo function, it will switch to high level automatically after 3 minutes and
the icon will stay on under high level.
Under standby mode, press the “Lighting” button once to turn on the light and repress to turn off.
Each press will trigger a tick from the buzzer. The “Lighting” button only controls the light.
Under power-on mode, press the “Low” button and the impellers will rotate at low speed to inhale
smoke (which shows the low level is switched on). Repress the button to turn off.
Warning
1.There is a fire risk if cleaning is not carried out in accordance with the instructions.
2.Cleaning and maintenance shall be conducted under outage. Electrical components such as motor, switch, and
connector shall not be spoiled by water so as to prevent from accidents.
3.It's prohibited to wash with water so as to prevent accidents.
4.Stove fire shall be extinguished timely when it is not used; do not flambe under the range hood and it's
prohibited to bake food under range hood directly to prevent range hood from damaging and causing accidents.
5.If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
6.Accessible parts may become hot when used with cooking appliances.
Range Hood