User Manual

Note: In case of installing the filer mesh, face the side with screw holes inwards.
Removal of filter mesh
Align the cross screwdriver with the screw hole and raise
it upward forcibly meanwhile rotating it counter- clockwise
about 120° , so as to remove the screw out of the cross
slot of the exhaust fume collecting hood. Hold the bottom
of the mesh with one hand, and remove the screw on the
other side with the other hand by the cross screwdriver.
Hold the two screws on the filter mesh with both hands
and pull it down to detach the two prongs inside from
the filer mesh. Then pull the filter out as per the arrow
direction to remove it.
Note: Installation steps of the lights and switches
are opposite to the removal steps.
CXW- 200- 8301CXW- 200- 8301
8321
CXW- 200- 8301
CXW- 200- 8301CXW- 200- 8301
8321
Removal of switch
Switch
●Removal of A817 switch
●Removal of A815 switch
After removing the spotlight, remove the two screws on
the switch with a cross screwdriver and move the switch
assembly diagonally upward to take it out from the lamp
hole for repair and replacement.
Untighten two screws on the small plate to remove the
plate.
Remove the two screws on the switch cover plate and
then rotate the cover plate to pull out the switch
assembly for maintenance and replacement.
Range Hood
11
Lamp information
Lamp image
Lamp Type(A817)
Voltage
Dimension
Rectangular LED
2W
12VDC
see the lamp image
52
252
25.6
Max Power
A817
A815
29.7
57.5
34
Ø
7
2
Lamp Type(A815)
Round LED