User Manual

Table Of Contents

Air passage

Electric motor

Housing

Main hood panel

Drawing panel

Oil cup

Retaining ring

Impeller

Cap

Cover plate

Filter mesh

Filter screen

Switch

Top cover plate

A817

Range Hood

Removal steps

1. Pull out the plug;

2. Unscrew the four screws from the back of the main hood panel. Tilt the panel forward to a certain angle, and

then pull it up forcibly;

3. Remove the drawing panel from the main hood panel;

4. Use a cross screwdriver to unscrew the fastening screws on the cover to remove the cover;

5. Unscrew the fastening screws on the retaining ring to remove the retaining ring;

6. Unscrew the cap clockwise and take out the impeller vertically;

7. Remove the oil cup and the filter mesh by means of removing the fastening screws with a cross screwdriver.

Installation steps are opposite to the removal steps.

(When you install the impeller, please add some lubricating oil on the shaft hole of it. ）

Note: Step 3 is unnecessary if no drawing panel is installed.

Removal steps of the whole range hood