User Manual

Installation
7
500(505)
60
0-
8
0
0
65
0-
7
5
0
80
0-
9
0
0
10
Ceiling
Removable panel
Removal baffle
(Figure Installation method of
hood without removable baffle)
1-1
CXW-20 0-831 2
Figure 2
Figure 3
100
468
Ceiling hole sizes( )
Figures in brackets are specific to the A815 hood
Projection size of the hood top
500(505)
895
Walls
Hole size of the exhaust pipe Ø200
●Install hitching feet
According to the dimension of hitching feet, drill four 60-70mm deep holes (overlarge holes are prohibited) accordingly
with an 8mm diameter drill bit. Press the expansion pipe into the holes, and then fix the hitching feet reliably with 4
provided ST4×60 wood screws. Drill a hole with diameter of 10mm and depth of 50-55mm at the position 65mm above
the four holes and insert the M6 metal expansion pipe into the hole. (See Figure 2)
A817
A817
6
0
0
-
8
00
65
0-
7
50
8
0
0-
9
0
0
10
35±2
Hitching foot stopper
Hitching foot
235
110
55
55
495
65±2
(Figure Installation method of hood with removable baffle)
(Figures in brackets are specific to the A815 hood)
1-2
●Determine the position
Ceiling
Drawing panel
Mounting hole of
the drawing panel
Main hood panel
ST4X18
self-ta pping
The hood shall be installed right above the hob. The minimum distance between the bearing surface of cooking
appliance and the lowest part of hood is 650mm (larger space specified in the installation instruction of gas hob shall be
considered. The distance for electric cooker may be reduced appropriately, depending on the actual situations)
Note: All data units in the following figures are in mm.
The size of removable baffle (reference: 430mm) can be adjusted according to the actual situations. The installation pitch of
holes is shown in Figure 2. The hood body shall be centered vertically and kept level. Ceiling hole size is shown in Figure 3.
Range Hood
A817