Instructions for use

13
Plug all servo cables into the designated out-
puts of your receiver (dependent on the ma-
nufacturer). The servo leads of the aileron
are marked with shrinkable tubing. The ex-
cessive lengths of the leads can be stashed
away in the back of the fuselage.
07
Now connect the ESC (electronic speed con-
troller) to the three motor wires and to the
designated output of the receiver. Check the
correct running direcon of the motor (clock-
wise rotaon in ight direcon). If the motor
is running in the wrong direcon, only change
two of the three motor wires. Use velcro tape
or xing foam to mount the ESC on the boom
side of the fuselage behind the baery board.
If necessary, secure the wire leads so that they
can’t get into the motor.
05
Use velcro tape on the boom of the fuse-
lage or xing foam to x the receiver and all
wire leads behind the wing screws.
08
Install the enclosed aluminum clamping cone
to the motor sha. Tighten the screw nut ca-
refully because of the aluminum thread. Use
3mm bolts and lock rings to x the blades on
the center part. Install the spinner.
06
ENGLISH