Instructions for use

15
Hint: A mechanically well adjusted model is
quite important. Therefore make sure that
you take your me, adjusng your model.
13
Use epoxy to glue the aluminum pressing
disk into the drill holes on the upper side of
the wing. Remove the plasc sheet before-
hand. Then use the wing screws to x the
wing. Glue the 3mm torsional pin into the
root rib of the right part of the wing (slightly
roughen and degrease the adherend at rst).
Hint: The wing connector can also be glued
into this part of the wing. This way you can
prevent the loss or neglect of the connector
even though the pack size increases slightly.
14
Aer all electrical adjustments are nished
and the rods are nely adjusted; use UHU-
Por to glue the servo opening covers and rod
covers.
16
Use epoxy to glue both 3mm torsional pins
into the front drill holes of the wings (slightly
roughen and degrease the adherend at rst).
15
ENGLISH