User Manual

12
ENGLISH
ASSEMBLY THE FUSELAGE
Use the cover to seal the servosha. In order
to glue the cover to the frame of the sha
use UHU Por or double-sided tape.
03
Install the elevator with the enclosed M3x10
screws on the fuselage and insert the ele-
vator linkage into the drillhole of the rud-
derhorn. Make sure to carefully ghten the
screws, without pung too much pressure
on the surface.
01
Twist one clevis onto the thread of the
rudder’s rod. Again, please make sure that
the rudder is placed in neutral posion du-
ring a 90°posion of the servohorn. Correct
the length of the clevis rods, if needed.
04
Check the length of the elevator linkage and,
if needed, adjust it by adjusng the length of
the clevis rods. The rudder should be placed
in neutral posion during a 90°posion of
the servohorn.
02