Operating instructions

A = BL motor socket E = Roll servo
B = S-FHSS module servo F = Collective pitch
C = Binding button G = Tail rotor servo
D = Pitch-axis servo
Disconnect the brushless motor con-
nector before binding the transmitter
and before making any other adjust-
ments on the model.
Receiver settings (large case), S-FHSS module settings (small circuit board on the receiver):
Receiver status LED S-FHSS module status LED
No reception/ Very fast flashing Fast flashing
Binding required
Initialising transmitter signal Fast flashing Continuous light
Receiving transmitter signal Continuous light Continuous light
Preparing the transmitter, using the Futaba T8J as an example:
- Set S-FHSS modulation
- The transmitter must be set to swashplate mode H-1 (see T8J instructions, 8.1 Parameter, page 38)
- Reverse the roll (CH1), pitch-axis (CH2), throttle (CH3), tail rotor (CH4) and collective pitch (CH6) channels (see T8J instructions, 7.10
Servo reverse (SERVO REV), page 20)
10
Operating Instructions - BLUE ARROW CP120 S-FHSS RTB 2.4 GHz No. S2540
Installing the flight battery:
A
W
C
D
E
F
G