Specifications

CitySource 96 (Single colour)

1. DMX Software Uploader program is available from the ROBE web site at WWW.robe.cz.

2. Make a new directory ( e.g. Robe_Uploader) on your hard disk and download the software to it.

3. Unpack the program from the archive.

II.Fixture software updating.

1. Determine which of your port is available on your PC and connect it:

- with the DMX input of the fixture if you using the flash cable RS232/DMX

- with the DMX input of the Robe Universal Interface if you using the USB cable.

Disconnect the fixture from the other fixtures in a DMX chain. Turn both the computer and the fixture on.

Make sure the lamp is switched off (only if the fixture involves a lamp).

2. Switch the fixture to the updating mode:

1 Use the UP/DOWN buttons to find “SPEC.“ menu.

2 Press the ENTER button.

3 Use the UP/DOWN buttons to select “ uPd.“ item.

4 Press the ENTER button

5 Use the UP/DOWN buttons to select “ yES“ option

6 Press the ENTER button

Note: If you do not want to continue in software update, you have to switch off and on the fixture

to escape from this menu.

3. We recommend to cancel all running programs before start of the Software Uploader.

4. Run the Software Uploader program. Select desired COM and then click on the Connect button.

If the connection is OK, click on the Start Uploading button to start uploading. It will take several minutes

to perform software update. If the option "Incremental Update" is not checked, all processors will be

updated (including processors with the same software version).

If you wish to update only later versions of processors, check the Incremental Update box.

Avoid interrupting the process. Update status is being displayed in the Info Box window.

When the update is finished, the line with the text “The fixture is successfully updated‘will appear in

this window and the fixture will reset with the new software.

Note: In the case of an interruption of the upload process (e.g. power cut), the fixture keeps the updating mode

and you have to repeat the software update again.

For example: The fixture was switched off before finishing software upload. After switching again the fixture on,

the fixture is still in the updating mode and the display is dark. Restart the Software Uploader program and repeat

software update from your PC.

Select DreamBox1

if the USB port is

used.

Select COM if the

seriál port is used.