Specifications

6. Align the new lamp (see instructions below)

7. Reset „Lamp On Time” and „Lamp Strikes” counters

in „Fixture information” menu.

Do not operate this xture with open lamp cover!

4.3 Lamp adjustment

The lamp holder is aligned at the factory.Due to differences between lamps, ne adjustment may improve light

performance:

To align the lamp:

1. Switch on the xture and after reset turn on the lamp.

2. Cancel all effects, open the shutter and focus the light on

aat surface (wall) using either DMX controller or function

„Lamp adjustment” in „Special functions menu”.

3. Center a hot spot (the brightest part of the beam) using the

three

adjustment screws “A, B, C” (4 mm Allen screws). Turn

one screw by one screw to drag the hot-spot, diagonally across

the projected image. If you cannot detect the hot spot, adjust

the lamp until the light is even.

To reduce a hot-spot, pull the lamp in by turning all three

screws „A, B, C” clockwise 1/4-turn at a time until the light

is evenly distributed.

If the light is brighter around the edge than it is in the cen-

ter, or if light output is low, the lamp is too far back in the

reector. „Push” the lamp out by turning the screws “A, B,

C” counterclockwise 1/4-turn at a time until the light is bright

and evenly distributed.

4.4 Replacing colour lters

DANGER!

Install the colour lters with the device switched off only.

Unplug from mains before!

1. Disconnect the xture from mains and allow it to cool.

2. Remove the bottom plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.

3. Turn the colour wheel to the desired position.The dichroic lters are xed on the colour wheel by the magnets.

4.Break the magnet´s initial hold by skewing the dichroic lter in a direction outlined on the picture below.

Protect

the glass lter with a piece of paper or clout during this action.

5. Insert the new dichroic lter into colour wheel.

6. Replace the bottom cover before applying power.

Remove the screws X and Y for re-lamping

3 adjustment scews “A, B, C”

Centering hole

Dichroic lter

Magnet