Specifications
8
4.5 Changing the front lens
The ColorWash 700E AT is supplied with the front Fresnel lens installed as standard.
If you wish to install a front wide-angle lens (optional),follow the instructions:
Switch the device off before changing the lens.Be careful.Front lens is heavy!
Changing the front Fresnel lens:
1.Remove the front lens using a athead screwdriver to unlock the four quarter-turn screws.
2.Unscrew the safety cabel from the lens
3.Screw up the safety cable to the wide-angle lens.
4.Place this lens and x it by locking the four quarter-turn screws.
4.6 Installing top hats
The ColorWash 700E AT can be tted with various types of the top hats-see chapter "Technical specications".If
you wish to install a top hat (optional),follow the instructions:
Switch the device off before installing the top hat!
Installing the top hat on the front lens-holder of the xture:
1.Put desired top hat onto a front lens-holder and fasten it by two fastening screws.
2.Secure the top hat by means of two securing springs (hook rst tip of the spring to the plastic projection in
the front lens-holder and the second one snap to the slot in the top hat).
Safety
cable
Quarter-turn screws
Quarter-turn
screws
Nut
Bolt
Slot
Securing spring
Plastic projection
Securing spring
Top hat
Fastening screw
Fastening screw
Lens-holder