User manual

7
4.2 Lamp adjustment
The lampholder is aligned at the factory. Due to differences between lamps,  ne adjustment may improve light performance.
Strike the lamp, cancel all effects, open the shutter and set the dimmer intensity onto 100 % and focus the light on a  at
surface (wall) or use function
„LAAd”
in the
Special functions
. As the optimum distance of the lamp from lens was
adjusted during the installing or changing the lamp (by turning the screw
„A”
), it is necessary to adjust only the second
position by turning the screw
„B”
, in order to center the hot-spot (the brightest part of the beam).
If the hot spot seems to be too bright, you can lower its intensity by moving the lamp closer to the re ector. Do so by
turning the srew
„A”
until the light is evenly distributed.
If the light on the edge seems to be brighter as in the center, the lamp is too close at the re ector. In this case, you need
to move the lamp away from the re ector until the light is evenly distributed and the beam appears bright enough.
4.3 Inserting/Exchanging gobos and colours
DANGER!
Install the colours and gobos with the device switched off only.
Unplug from mains before!
Turn off the lamp and allow it to cool for at least 10 mi-
nutes. Disconnect the  xture from power.
To insert the gobos or colours, open the top cover of the
moving-head by loosening the 3 quarter-turn fasteners on
the top cover and follow the instructions below:
Rotating gobo-wheel:
1. Gently bend out the gobo module to release it from the
distance holes and eject it from the pressing snap.
2. Press the ends of the  xation ring together with an
appropriate tool and remove it from the gobo holder.
Remove the gobo and insert the new gobo. Press the
ends of the  xation ring together and insert it in the
front of the gobo.
3. Put the gobo module back under the pressing snap
and push it to the 2 distance holes.
CAUTION!
The gobo module with the magnet must be placed
in the same position as it was placed before gobo
replacement!
CAUTION!
All Gobos were designed for 250 W lamp only.
Do not use them in the  xture with more powerful lamp!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!