DMX CONTROL 24 PRO CT Table of contents 1. Safety instructions ......................................................................................................... 4 2. Operating determinations ............................................................................................. 4 3. Description of the device .............................................................................................. 5 4. Installation ...........................................................................
CAUTION! Keep this device away from rain and moisture! Unplug mains lead before opening the housing! FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOU INITIAL START - UP! 1. Safety instructions Every person involved with installation and maintenance of this device have to: - be qualilfied - follow the instructions of this manual CAUTION! Be careful with your operations.
or dust. There should not be any cables lying around. You endanger your own and the safety of others! Operate the device only after having familiarized with its functions. Do not permit operation by persons not qualified for operating the device. Most damages are the result of unprofessional operation! Please use the original packaging if the device is to be transported.
- DMX VALUE- DISPLAY Shows current DMX value. 7 - AUTO TRIG BUTTON If the LED shines, the controller is in Auto-mode (normal operation without sound-control). 8 - MUSIC TRIG BUTTON If this LED shines the controller is in Audio-mode (operation with sound-control). 9 - MANUAL TRIG BUTTON With the Manual Trig -button, you can jump from one step to another. 10 - PROGRAM-DISPLAY Shows program steps. 11 - PROGRAM UP/DOWN BUTTONS For selecting the program.
4. Installation 4.1.Sound-control The sound-control either works via the ¼” mono jack-socket or the built-in microphone. If the DMX CONTROL 24 PRO CT is supposed to work via a soundsignal at the Audio In-socket, connect the ¼“ jack socket with the soundsignal of your headphones output or a second adjustable output (if existing) of your mixer, or with the loud-speaker output of your amplifier.
4.3 Fixture addressing Projector addressing Please note that the DMX CONTROL 24 PRO CT assigns the DMX-starting addresses every 6 steps. You have to address every projector to the respective starting address. Otherwise, the channel assignment will not be correct. All projectors with the same starting address work synchronically. Projector Projector 1 Projector 2 Starting address 1 7 Projector Projector 3 Projector 4 Starting address 13 19 International 4.
If you want to return to the factory setting, press and hold the STEP and TIME-button at the same time for 10s. If you want delete dedicated the times of the program steps and set the programs no. 21-30 to minimum length (1 step), press and hold the PROGRAM- button and then press the ENTER- button. Hold both buttons until the reset has run (approximately 3 s). Set up mode is finished by pressing the ENTER- button.
of current step. You can change either step. For example, if you want to shorten the program, set the desired step as last by pressing the STEP- button repeatedly. The little dot shines behind the number of step. If you press the STEP- button again, the little dot will be switched Off. By this procedure you can change all steps. Completion of programming Press and hold the ENTER- button and let the PROGRAM-button loose so that the PROGRAM-LED stops flashing.
