Version 1.
LiteWare HO Table of contents 1.Introduction ................................................................................................................................................................. 3 1.1 Weights and dimensions ...................................................................................................................................... 3 1.2 Accessories ..........................................................................................................................
LiteWare HO 1.Introduction LiteWare HO with wireless DMX is a stand-alone light source. The unit can be controlled by DMX transmitted wirelessly and in stand-alone operation using 50 preset colours and 20 preset fade and snap sequences.
LiteWare HO 2. Charging the system There are two charging methods available for LiteWare HO. • flight case charger system • single unit charger Both charger options are designed specifically for LiteWare HO. Please DO NOT use any other charging system as this can damage the battery base unit. The charging cycle is approximately 8 hours. 2.1 Flight case charger system 1 Ensure that the flight case is plugged into a mains supply with the supplied mains lead. 2 Place the LiteWare HO into the flight case.
LiteWare HO 3. Operating the system This chapter describes: • Switching the system on/off • Operating modes (wireless and standalone) • The controls and display • Personalities Full operating instructions are provided in this chapter. In addition, the bottom of the battery base unit has a label with various operational and safety information. Below is a schematic of the label: 3.1 Switching the system on/off Press and hold the TOP button for 1.5 seconds.
LiteWare HO In RGB mode, DMX channel allocations are as follows: Start address red level Start address + 1 green level Start address + 2 blue level For example, if your start address (the first channel that the unit listens to) is 001, then the red level is allocated to 001, green to 002 and blue to 003. In wireless DMX mode, the battery base unit holds the last DMX value upon loss of signal or DMX. The battery base unit stores this level when turned off so it can be resumed when it is powered back up.
LiteWare HO Run times for HO when on full white Percentage of maximum output 100 90 80 70 60 50 40 Number of pushes of top button 1 2 3 4 5 6 Run time (hh:mm) 7:21 7:53 9:58 13:35 17:48 27:38 67:21 3.3 The controls and display On the bottom of the battery base unit are the UP and DN buttons, and the ADDRESS display panel. UP and DN buttons The UP and DN buttons are used to select an address. Button Up DN Behaviour Increments the address by 1. Decrements the address by 1 (001 is the lowest value).
LiteWare HO Indicator POWER RADIO DMX LINK LED DRIVE Description Shows whether the battery base unit is on or off. Shows when a radio DMX link is present Shows when a channel is ‘on’. 3.4 Personalities To access personalities press and hold the UP and DN buttons simultaneously until the display reads “Per”. The battery base unit is now in Personality mode. To choose a personality use the UP and DN buttons (single presses, as for selecting normal addresses).
LiteWare HO 3.
LiteWare HO 4. Safety information WARNING! Class 2M LED product. Do not look into the beam from a distance of less than 40 cm (16 inches). Do not stare into the beam for extended periods at a short distance. Do not view the beam directly with optical instruments. This product is for professional use only. It is not for household use. This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
LiteWare HO DISPOSING OF THIS PRODUCT Robe Lighting products are supplied in compliance with Directive 2002/96/EC of the European Parliament and of the Council of the European Union on WEEE (Waste Electrical and Electronic Equipment), as amended by Directive 2003/108/EC, where applicable. Help preserve the environment! Ensure that this product is recycled at the end of its life. Your supplier can give details of local arrangements for the disposal of Robe Lighting products.