Specifications

LiteWare HO

3. Operating the system

This chapter describes:

• Switching the system on/off

• Operating modes (wireless and standalone)

• The controls and display

• Personalities

Full operating instructions are provided in this chapter. In addition, the bottom of the battery base

unit has a label with various operational and safety information. Below is a schematic of the label:

3.1 Switching the system on/off

Press and hold the TOP button for 1.5 seconds. The button LED switches on to show the battery base

unit is on. Press and hold the TOP button again to switch off.

3.2 Operating modes

There are two operating modes:

• Wireless DMX mode (uses addresses in range 1-512)

• Stand-alone mode (uses addresses in the range 601-670)

Each address value corresponds to an output colour at the head. To select an address you use the UP

and DN buttons, which are situated on the bottom of the battery base unit (see chapter The controls and display

for instructions).

Wireless DMX mode (address 001-512)

Wireless DMX mode uses addresses 001-512.

Output level in wireless DMX mode is controlled by the wireless DMX controller that you use with the

system; the LiteWare HO battery base unit responds to the DMX levels it receives.