Version 1.
StageFaze 1500 AT Table of contents 1.Introduction...................................................................................................................... 3 2.Cautions ........................................................................................................................... 3 3.Unpacking & Inspection.................................................................................................. 4 4.Description of the device...................................................
1.Introduction Thank you for choosing an ROBE StageFaze 1500 AT. You now own a rugged and powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your ROBE Stage Faze 1500 AT machine for years to come. Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine. 2.
3.Unpacking & Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The StageFaze 1500 AT comes with the following items: - 1 tank, lid with quick connector,silicon tube and air valve filter - 1 user manual Before beginning initial setup of your ROBE Faze machine, make sure that there is no evident damage caused by transportation.
. Fluid 5.1 General notes The ready-to-use StageFaze 1500 AT fluid for use in this device is available from your local ROBE distributor. To guarantee trouble-free operation the special “StageFaze 1500 AT“ must be used. Use of other liquids will void the manufacturer‘s warranty and can be dangerous to your health. PLEASE NOTE: The vaporizer of the machine does not have to be cleaned! Cleaners, available on the market, can damage the vaporizer! 5.
.2 Putting into operation Warning: Never connect the StageFaze 1500 AT to a dimmer or switchpack! This may destroy the machine. Connect the power plug to the mains supply. Make sure the correct voltage is selected.Switch on the power switch (10). A P and two figures appear on the LED display e.g.: After 60 Seconds, the StageFaze 1500 AT is heated up. Press the Enter-button once to start the Faze process. The green Active-LED will be lit. After a short delay the machine begins to Faze.
6.4 Operating via DMX 512 Connecting the StageFaze 1500 AT to a DMX desk, use the 3XLR sockets [12], at the rear side of the fixture. As soon as the machine receives a correct DMX signal, the yellow DMX LED will be lit. Please note: The StageFaze 1500 AT uses two channels on your DMX desk! First Channel = Pump, second Channel =Fan Adjusting the DMX start address 1) Press the Mode-button [14] at the control panel until three figures appear on the LED-display [17] (see Fig. 3).
2) Press the Enter button once to switch to the HDCS Menu. The red Timer/Profile-LED will be lit. 3) Adjust settings 1 to 7 according to the chart below, using the Up/Down buttons and pressing the Mode button to switch between the settings. These settings are stored in non-volatile memory. You don‘t have to run the Profile or press the Enter button in order to „save“ the settings. All settings can be changed as described at any time.
Auto start If the timer is in operation and you disconnect the machine from the mains cable, the StageFaze 1500 AT will re-start in the Timer-Mode as soon as it‘s reconnected to the mains. To stop this press the Mode-button for more than 2 seconds or by switching to „ESC“ in the Timer-Mode and then press the Enter-button. 7. Cleaning,care and maintenance Remove the filter, which protects the fan against dust and dirt, from time to time and clean it.