Installation Guide

Installation Notice - Wall Anchor Change
This notice is intended to be used in combination with the installation Instructions provided with your Robern product.
To ensure correct installation, rst identify the type of wall anchors supplied with your Robern xture, BLUE 203-1309 or RED SS680,
then follow the associated installation method.
BLUE 203-1309 #10 Wall Anchor
If your Robern product has been equipped with the BLUE 203-1309 #10 wall anchors, please install the wall anchors as follows:
1. Drill a 5/16- hole into drywall/wallboard, plaster, brick, or concrete.
2. Insert the wall anchor into hole until anchor ange is ush with the wall.
3. Insert the #10 screw and tighten until contact with Z bar and/or Z clip is achieved.
4. Continue to tighten screw until there is a strong resistance. DO NOT OVER TIGHTEN.
HOLLOW-WALL ANCHOR INSTALLATION METHODS
RED SS680 #10 Wall Anchor
If your Robern product has been equipped with the RED SS680 #10 wall anchors, please install the wall anchors as follows:
1. If no furring strip or stud is available, use the supplied plastic anchors. Drill a 9/32" (7mm) hole for wall anchor.
2. Insert wall anchor into hole until ange is ush.
If your product is equipped with washers, fasten xture by inserting screw with washer through xture and into anchor. If your product is
not equipped with washers, insert screw through xture and into anchor.
3. Tighten screw until it is tight against xture. Keep turning screw at least four more times as shown.
Contact Rabern Customer Service [phone] of you have any questions.