Specification Sheet

1
Robern
701 N. Wilson Ave.
Bristol, PA 19007
1.800.877.2376
DECORATIVE FRAMED WALL MIRROR
INSTALLATION INSTRUCTIONS
General Notes
Unpack the mirror and check the box for all hardware and loose parts as follows:
Mirror
Hardware Bag
Be sure you have all the contents listed above and in the Parts List on page 2.
Save these instructions for future use and reference.
An improper installation voids the warranty. Installed mirrors cannot be returned.
If you experience any problems with your mirror, contact your dealer or Robern directly.
Robern • 701 N. Wilson Ave • Bristol, PA 19007
1-800-877-2376 •
FAX [phone]
Limited Warranty — One Year Term (see page 2)
■
■
Installing the Mirror
209-1158 Decorative Framed Wall Mirror 01/28/13
©2013 ROBERN, INC.
ALL RIGHTS RESERVED
Figure B
BOTTOM OF MIRROR
OUTLINE OF MIRROR
VERTICAL HANG BARS
Figure A
24"
DM1630MGXX - 10"
DM1640MGXX - 10"
DM2030MGXX - 14"
DM2040MGXX - 14"
DM2430MGXX - 18"
DM2440MGXX - 18"
"Z" CLIP
"Z" CLIP
CENTERLINE OF MIRROR
PADS PLACED ON
WALL WITHIN 1/2"
TO 1" OF THE BOTOM
AND SIDE OF MIRROR
WALL
ADHESIVE PAD
(STICKS TO BOTH MIRROR AND WALL)
MIRROR
"Z" CLIP
HANG
BARS
1. Determine the placement of the two “Z” clips (see Figure A).
• Carefully select the mirror location
• Mark the bottom and side locations of the mirror
on the wall with a pencil
• Use Figure A to mark the “Z” clip locations
2. Install the two “Z” clips
• Place the “Z” clips in the locations shown in Figure A
using the supplied washers and SS674 #10X2” (50.8
mm) screws
Note: You must use the
supplied plastic anchors
when there is no wall stud at the “Z” clip location.
See Poly-set Anchor Instructions on page 2.
3. Peel the paper backing from one side of the 2”X2” (50.8
mm) double-sided adhesive pads and adhere the pads to
the back inside corners of the glass part of the mirror
as shown in Figure A.
4. Hang the mirror on the “Z” clips (see Figure B for location of
hanging bars).
If the mirror needs to be repositioned slightly,
adjust the “Z” clips up or down until the mirror is level.
5. Tilt the bottom of the mirror out slightly (Figure B) and peel
the backing paper from the other side of the adhesive pads.
Push the mirror against the wall firmly until the pads stick to
the wall.
15 1/8"
19 1/8"
23 1/8"
29 7/8", 39 1/2"