Installation Sheet

Part no. 209-1330 01/06/21

Vesper Edgeline Lights

800.877.2376 www.robern.com

RECESSED INSTALLATION

4. With the electrical cover removed, support the cabinet on the edge of the recessed opening and feed the eld wire through the eld

wire strain relief at the back of each enclosure.

5. Push the cabinet assembly into the recessed opening until the back of the cabinet ange is tight to the nished wall surface.

6. Using a level, level and plumb the products in the opening. Shim as necessary. Using a square, make sure the cabinet is square in

all axis.

7. Make the electrical connection according to the electrical diagram on page 8.

Note: Refer to your cabinet's Instructions to insure there are no additional steps required prior to proceeding.

8. Mount the cabinet in place using the #10 Screws [SS674] provided with the cabinet.

RO Width =

Width of cabinet +

width of lights - 3/4" (19 mm)

RO Height =

Height of cabinet - 3/4" (19 mm)