Installation Sheet

800.877.2376 www.robern.com

Installation or Assembly Instructions

Part no. 209-1329 rev. 03/25/20

Vesper Midline / Outline Light

Unpack the Light. Check the box thoroughly for all hardware and loose parts. Carefully inspect the xture for damage.

DANGER: Risk of personal injury. To avoid possible electrical shock, the electricity must be turned off at the circuit

breaker or fuse box before attempting any installation procedure.

DANGER: Risk of personal injury. To avoid possible electrical shock, the light xture must be properly grounded.

CAUTION: Grounding instructions for permanently connected products: This product must be connected to a grounded,

metal permanent wiring system or an equipment-grounding conductor must be run with the circuit conductors and connected to the

equipment-grounding terminal or lead on the product. All wiring should be done by a qualied licensed electrician.

IMPORTANT: Power for the lights should be provided separately from the electricity to the cabinet so that when lights are turned off,

cabinet electricity remains on.

NOTE: Requires minimum 120 VAC 15 amp circuit.

NOTE: Requires an approved compatible dimmer for installation (not included). Refer to the dimmer recommendation on page 2.

Observe all applicable electrical codes and building codes. Wire the light xtures in accordance with the electrical codes.

This xture is for indoor use only.

This installation may require the assistance of more than one person depending on your Light/Cabinet conguration.

NOTES

DANGER - RISK OF SHOCK -

DISCONNECT POWER BEFORE INSTALLATION