Installation Sheet

800.877.2376 www.robern.com

Installation or Assembly Instructions

Part no. 209-1329 rev. 03/25/20

Vesper Midline / Outline Light

STEP 4A - RECESS INSTALLATION

1. With the electrical cover(s) removed, support the cabinet on the edge of the recessed opening and feed the eld wire(s) through the

eld wire strain relief at the back of each enclosure(s).

2. Push the cabinet assembly into the recessed opening until the back of the cabinet ange is tight to the nished wall surface.

3.Using a level, level and plumb the products in the opening. Shim as necessary. Using a square, make sure the cabinet is

square in all axis.

4. Make the electrical connection(s) according to the electrical diagram on page 7.

Note: Refer to your cabinet's Instructions to insure there are no additional steps required prior to proceeding.

5. Mount the cabinet in place using the #10 Screws [SS674] provided with the cabinet.

RO Width =

Width of cabinet +

width of lights - 3/4" (19 mm)

RO Height =

Height of cabinet - 3/4" (19 mm)

Corner block 2x4

4x corners

2-1/2" (63.5 mm)