Installation Guide

NOTE:
IF WALLS ARE OUT OF SQUARE IT MAY BE
NECESSARY TO SHIM OUT THE CABINET AT ONE OR
MORE OF THE RETAINING CLIPS. USE WOOD SHIMS
AND POSITION THEM AT THE POINT WHICH KEEPS
THE DOORS IN PLANE.
RECESS MOUNT CABINETS
1. WALL OPENING CHART:
MODEL WIDTH R.O. MODEL HEIGHT R . O
1 6 14 1/2” 28 24”
2 0 18 1/2” 38 34 3/4”
2 4 22 3/4”
3 2 30 3/4”
3 6 34 3/4”
4 8 46 3/4’
6 0 58 3/4’
RECOMMENDED HEIGHT FROM FLOOR TO
BOTTOM OF ROUGH OPENING:
28” HIGH 48” FROM FINISHED FLOOR
38” HIGH 41” FROM FINISHED FLOOR
BE SURE 38” HIGH CABINET CLEARS FAUCETS
2. DRILL A MINIMUM OF FOUR HOLES WITH A 3/16” DRILL BIT AS
SHOWN. OPENING SHOULD BE FRAMED FOR CABINET, IF NOT
BE SURE TO DRILL A STUD LOCATIONS. DRILL VERY
CAREFULLY TO AVOID DAMAGE TO CABINET. INSTALL WITH
PUSHRODS AT BOTTOM. DO NOT USE WASHERS.
NOTE:
DO NOT INSTALL CABINET THRU SHELF PIN HOLES!
THE DOOR FRAME WILL NOT BE PROPERLY
SUPPORTED AND WILL RACK OUT OF SQUARE. THE
CABINET WARRANTY IS VOID WHEN INSTALLED IN
THIS MANNER.
-3-
DOOR INSTALLATION AND ALIGNMENT
1. IF ALIGNMENT OF DOORS IS NECESSARY LOOSEN THE 4
PHILLIPS HEAD SCREWS AT THE HINGES. MOVE
THE DOOR TO THE PROPER LOCATION (BE SURE AT LEAST 1/8”
IS BETWEEN EACH DOOR). RETIGHTEN CAREFULLY TO AVOID
STRIPPING. IF DOORS CANNOT BE ALIGNED PROPERLY THE
CABINET IS OUT OF SQUARE. CHECK FRAME OF CABINET WITH
A FRAMING SQUARE AND ADJUST.
2. IF DOORS DO NOT CLOSE PROPERLY OR IN PLANE, THE
CABINET MAY BE MOUNTED ON A WALL WHICH IS NOT FLAT.
SHIMMING AS SHOWN TOP LEFT WILL BE NECESSARY UNDER
THE SIDE OR CORNER WHICH WILL BRING THE CABINET FACE
IN PLANE.
3. REPLACEMENT DOORS ARE SHIPPED WITHOUT HINGES OR
TAPERED DOOR STOP. REMOVE THESE ITEMS FROM THE OLD
DOOR AND REINSTALL SO THAT PUSHROD ENGAGES TAPERED
DOOR STOP AND OPENS DOOR.
USE AND CARE OF YOUR ROBERN CABINET
1. UNDER NO CIRCUMSTANCES SHOULD AN
AMMONIA BASED GLASS CLEANER BE USED ON
MIRRORS. USE ONLY A LINT FREE POLISHING
CLOTH ON YOUR CABINET. DAMPEN SLIGHTLY WITH
RUBBING ALCOHOL FOR STUBBORN MARKS.
2. USE A MILD LIQUID CLEANER AND WATER ON THE ALUMINUM
SURFACES OF THE CABINET. AVOID ALL CLEANSERS WITH
ABRASIVES AS THESE WILL SCRATCH THE SURFACE OF THE
CABINET.
3. SHELF PINS ARE ADJUSTABLE EVERY 2”. THEY ARE
DESIGNED FOR A TIGHT FIT, TWIST IN PLACE. GREY PLASTIC
PLUGS ARE SUPPLIED IN YOUR HARDWARE BAG TO FILL THE
SHELF PIN HOLES NOT IN USE.