Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
BLING PENDANT
S1006Page 1 of 2
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read completely before beginning the installation of
your xture. We STRONGLY recommend installation be completed by a licensed electrician.
*Do not connect the electricity to the xture until it has been completely assembled. Turn the power to xture o before replacing bulbs.
*Review all instruction pages before installing the xture.
ASSEMBLY INSTRUCTIONS
1. SHUT OFF THE ELECTRICAL SUPPLY FROM THE MAIN FUSE
BOX/ CIRCUIT BREAKER.
2. Remove all parts from the carton and discard packing material.
3. Remove mounting plate (B) from canopy (D) by removing screws (E).
4. Carefully pull wiring from outlet box. Thread wires through center hole
in mounting plate (B). Attach mounting plate (B) to outlet box using
screws (C), provided.
5. Measure desired drop for xture to hang from outlet box. Using chain
pliers (not included), remove links from chain (H) to achieve drop.
6. Connect hang straight (F) to chain (H) using quick link (G).
7. Guide the wires exiting the top of housing (I) through chain links (H).
Continue to guide wiring through center hole in canopy (D).
8. Connect hooks (K), at the end of arms (J), to loops (L) attached to the
top ring of the xture. See FIG. A for illustration.
9. Lift xture to ceiling outlet box and make proper electrical connections
described in steps 10 - 12. A licensed electrician is recommended.
10. Attach ground wire from xture (green or silver in color) to ground wire
from outlet box. Fasten wires together with wire nut (A) and tightly wrap
connection with electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to
hot wire from outlet box. Fasten wires together with wire nut (A) and
tightly wrap connection with electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire)
to neutral wire from outlet box. Fasten wires together with wire nut (A)
and tightly wrap connection with electrical tape.
13. Carefully push wire connections back into ceiling outlet box. Slide
canopy (D) over mounting plate (B). Thread screws (E) into vacant holes
in canopy (D) to secure xture to ceiling.
14. Install 2 - 60W max. Type G, candelabra base bulbs into the sockets.
(E)
(G)
(H)
(I)
(K)
(L)
FIG. A
(F)
(B)
(C)
(A)
(OUTLET BOX)
(D)
(J)
(M)
(N)
FIG. CFIG. B
(O)
GLASS DROP INSTALLATION:
1. Remove packaging from glass drops. NOTE: The xture is designed to
have alternating sizes of glass drops (M) and (N) on each ring. It is
recommended that you install the glass drops on the bottom ring rst and
continue working up towards the top ring.
2. From below metal band (O), place the wire on glass drop (N) through one
of the holes in the bottom of metal band (O). Insert the wire at an angle so
it exits the hole on the inside of the metal band (O) as shown in FIG.B.
3. Take the exposed portion of the wire and bend it down to secure the
placement of the glass drop as shown in FIG. C.
4. Repeat steps 2 and 3 to install glass drop (M).
5. Repeat steps 2 - 4 for each ring until glass drops (M & N) are completely
installed.
CARE INSTRUCTIONS:
*To clean, wipe a soft cloth. DO NOT use any chemical or abrasive cleaners.
*White gloves have been shipped with each xture. Please wear gloves to
keep the xture clean during installation.