Installation Guide

1008
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read completely before beginning the installation of
your xture. We STRONGLY recommend installation be completed by a licensed electrician.
*DUE TO THE WEIGHT OF THIS ITEM, YOUR CEILING OUTLET BOX MUST BE RATED FOR FIXTURES UP TO 150 LBS.
FOLLOW MANUFACTURERS INSTRUCTIONS FOR CEILING OUTLET BOX INSTALLATION.
*Do not connect the electricity to the xture until it has been completely assembled. Turn the power to xture o before replacing bulbs.
*Review all instruction pages before installing the xture.
*This xture is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS
1. SHUT OFF THE ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing material. Remove mounting plate (B) from canopy (F) by removing screws (E).
3. Lift the mounting plate (B) to the ceiling outlet box. Once aligned, use a pencil to mark the locations of mounting holes (C) on the
outside edges of the mounting plate.
4. Set the mounting plate aside and drill small holes at the marked locations. Holes should be sized so anchors (P) t securely inside.
5. Push anchors (P) into the holes. Attach mounting plate (B) to ceiling outlet box using screws (D). Thread screws (Q) through holes
(C) and into wall anchors (P) for additional support in attaching the mounting plate to the ceiling.
6. Measure desired drop for xture to hang and add/remove extension tubes (J) as needed. Guide wiring through extension tubes
before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded nipple of one extension into/out of the threaded opening of the next
extension. Make sure electrical cord is pulled tight when threading extensions together to prevent damage to the wiring.
1
7. Place quick link (L) through loop (K) and loop
(M) to attach extensions to xture. Repeat steps
for remaining quick links, loops, and set of
extensions.
8. Lift canopy (F) to mounting plate (B) and make
proper electrical connections.
A licensed electrician is recommended.
9. Attach ground wire from xture (green or silver in
color) to ground wire from outlet box. Fasten
wires together with wire nut (A) and tightly wrap
connection with electrical tape.
10. Attach hot wire from xture (black in color or
smooth side of wire) to hot wire from outlet box.
Fasten wires together with wire nut (A) and
tightly wrap connection with electrical tape.
11. Attach neutral wire from xture (white in color or
ribbed side of wire) to neutral wire from outlet
box. Fasten wires together with wire nut (A) and
tightly wrap connection with electrical tape.
12. Carefully push wire connections back into ceiling
outlet box. Slide canopy (F) over mounting plate
(B). Thread screws (E) into the holes in canopy
(F) to secure xture to the ceiling.
13. Install eight 60W max. Type A bulbs
into the sockets.
ASSEMBLY INSTRUCTIONS FOR YOUR
BLING RECTANGULAR CHANDELIER
(H)
(I)
(G)
(F)
(J)
(K)
(L)
(A)
(OUTLET BOX)
(B)
(C)
(D)
(P)
(E)
(N)
(J)
(M)
(O)
(Q)