Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
FINEAS CHANDELIER
1519
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE BOX/ CIRCUIT
BREAKER..
2. Remove all parts from carton. Do not throw away any parts.
3. Remove quick link (G) from hang straight (F). Keep quick link (G) attached
to loop (H).
4. Remove cross bar (A) (with threaded tube (C) and hang straight (F)
(attached) from canopy (D) by unscrewing collar (E). Afx cross bar (A) to
ceiling outlet box using screws (B) provided.
5. Measure desired drop for xture to hang and add/remove extension tubes (I)
to reach desired position. Guide wiring through extension tubes before
threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded tube of one
extension out of/ into the threaded opening of the next extension. Make sure
wiring is pulled tight when threading extensions together to prevent damage
to the wire.**
6. Thread bottom extension tube (I) onto shade housing (M).
7. Carefully slide threaded collar (E) down extensions (I) until it rests on shade
housing (M). Carefully slide canopy (D) down extensions (I) until it rests on
collar (E).
8. Lift xture to ceiling and secure quick link (G) to hang straight (F). Carefully
guide wire through hang straight (F) and threaded tube (C) into ceiling outlet
box.
9. Make proper electrical connections noted in steps 10-12. A LICENSED
ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire
from outlet box. Fasten wires together with wire nut (N). Tightly wrap
connection with electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to hot wire
from outlet box. Fasten wires together with wire nut (N) and tightly wrap
connection with electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire) to
neutral wire from outlet box. Fasten wires together with wire nut (N) and
tightly wrap connection with electrical tape.
13. Gently push wire connections back into ceiling outlet box.
14. Slide canopy (D) up extensions (I) and hold ush against ceiling. To secure
position of canopy (D), slide collar (E) up extensions (I) and thread onto
hang straight (F). Turn until hand tight.
15. Remove ange (J) from socket (L). Place shade (K) onto socket (L). Thread
ange (J) back onto socket (L) to secure shade to xture. Repeat step for
remaining shades.
16. Install three 60W MAX. Type A, medium base bulbs into the sockets (L).
17. Reconnect main electrical supply at the fuse box/ circuit breaker and test
xture.
*These instructions are provided for your safety. It is very important that they
are read completely before beginning the installation of your xture.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED
ELECTRICIAN.
*Turn off power at switch before replacing bulbs.
*If any special control devices are used with this xture, follow the instructions
carefully to assure full compliance with N.E.C. requirements. If there are any
questions, contact a qualied electrical contractor.
IMPORTANT SAFETY INSTRUCTIONS:
(A)
(B)
(D)
(C)
(N)
(E)
(F)
(G)
(H)
(I)
(K)
(L)
(I)
(J)
(M)
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***