Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
RICO ESPINET RACER CHANDELIER
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(I)
(O)
(J)
(K)
(L)
(M)
(N)
1522
ASSEMBLY INSTRUCTIONS
**SHUT OFF ELECTRICAL SUPPLY AT CIRCUIT BREAKER**
1. Remove all parts from carton. Do not throw away any parts. Move arms (N) into
desired position by rotating each one at arm housing (K).
2. Remove quick link (G) from hang straight (F). Keep quick link (G) attached to loop
(H).
3. Remove cross bar (A) (with threaded tube (C) and hang straight (F) attached) from
canopy (D). Do this by unthreading collar (E) from hang straight (F). Canopy (D)
will slip over hang straight (F). Set the canopy (D) and collar (E) aside.
4. Ax cross bar (A) (with threaded tube (C) and hang straight (F) attached) to ceiling
outlet box using screws (B) provided.
5. Measure desired drop for xture to hang and add/remove extension tubes (I) as
needed. Guide wiring through extension tubes before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded tube of one
extension into/out of the threaded opening of the next extension. Make sure
electrical cord is pulled tight when threading extensions together to prevent damage
to the wiring.
6. Pull cord taut from above and thread bottom extension (I) onto threaded tube exiting
housing (J).
7. Slip collar (E) over extentions (I) so it rests on housing (J). Slip canopy (D) over
extentions (I) so it also rests on housing (J).
8. Lift xture to ceiling and secure quick link (G) to hang straight (F). Guide wire
exiting top extension (I) through the center of the hang straight (F) and threaded
tube (C).
9. Make proper electrical connections described in steps 10 - 12. A LICENSED
ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from xture (green or silver in color) to ground wire from
outlet box. Fasten wires together with wire nut (O) and tightly wrap connection
with electrical tape.
11. Attach hot wire from xture (black in color or smooth side of wire) to hot wire
from outlet box. Fasten wires together with wire nut (O) and tightly wrap
connection with electrical tape.
12. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral
wire from outlet box. Fasten wires together with wire nut (O) and tightly wrap
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are
read completely before beginning the installation of your xture.
*Turn o power at switch before replacing bulbs.
*If any special control devices are used with this xture, follow the instructions
carefully to assure full compliance with N.E.C. requirements. If there are any
questions, contact a qualied electrical contractor.
*We strongly recommend installation by a licensed electrician.
*This xture is UL rated for dry locations.
connection with electrical tape.
13. Carefully push wire connections back into ceiling
outlet box.
14. Slide canopy (D) up extentions (I) and hold ush
against ceiling. To secure position of canopy (D),
slide collar (E) up the extentions and thread it onto
hang straight (F). Turn until hand tight.
15. Install ve 100W MAX. Type A, medium base bulbs
into the sockets located inside of shades (L).
16. Move shade (L) into desired position by rotating at
joint (M). Repeat for remaining shades.
17. Reconnect main electrical supply at fuse box/ circuit
breaker and test the xture.
***To clean, use sot cloth only. Do not use any chemical or abraisive cleaners.***