Installation Guide

Assembly & Installation Instructions
Caution: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
***IT IS RECOMMENDED THAT A CERTIFIED, LICENSED ELECTRICIAN
INSTALL THIS FIXTURE***
***************************************************************************************
Warning: If any special control devices are used with this xture, follow the instructions
carefully to assure full compliance with N.E.C. requirements. If there are any questions,
contact a qualied electrical contractor.
**************************************************************************************
***DETERMINE REQUIRED MEASUREMENT BEFORE
MAKING CONNECTION-IT MAYBE NECESSARY TO
REMOVE SOME OF THE RODS TO OBTAIN THE
DESIRED LENGTH***
1.- CAREFULLY REMOVE ALL PARTS FROM THE BOX.
2.- REMOVE MOUNTING PLATE (B) FROM CANOPY (E) BY
LOOSENING SCREWS (C) PROVIDED.
3.- THREAD WIRES FROM THE J-BOX (A) THROUGH HOLE
IN MOUNTING PLATE (B).
4.- ATTACH MOUNTING PLATE (B) TO J-BOX (A) WITH
SCREWS (D) PROVIDED.
5.- REMOVE TUBES, IF NECESSARY, TO ACHIEVE
DESIRED LENGTH. TUBE (F) MUST REMAIN IN PLACE.
6.- SECURE THE TOP OF TUBE (G) TO THE BOTTOM OF
THE TUBE (F).
7.- SECURE THE THE CENTER OF LAMP (I) TO THE
BOTTOM OF TUBE (G).
8.- MAKE THE NECESSARY WIRING CONNECTIONS:
-CONNECT THE COPPER WIRE FROM THE
FIXTURE TO THE GROUND WIRE
-CONNECT THE ROUGH SIDE OF THE WIRE (THE
WHITE SIDE OF WIRE) FROM FIXTURE TO THE
WHITE WIRE FROM THE J-BOX
-CONNECT SMOOTH SIDE OF WIRE (OR BLACK
SIDE OF WIRE) FROM FIXTURE TO BLACK WIRE
COMING FROM THE J-BOX.
9.- SLIDE PART (M) INTO THE SLOT IN PART (N).
10.- SLIDE CANOPY (E) OVER THE MOUNTING PLATE (B)
AND SECURE WITH THE SCREWS (C) PROVIDED.
11.- REMOVE FLANGE (K) FROM THE SOCKET (L). ATTACH
SHADE (J) TO THE TOP OF SOCKET (L) AND SECURE
WITH FLANGE (K).
12.- INSERT RECOMMENDED 4-60W MAX.
CANDELABRA LIGHT BULBS INTO SOCKET.
C.
D.
B.
A.
F.
G.
I.
M.
N.
K.
E.
J.