Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR

1877

HOPE WALL SCONCE

IMPORTANT SAFETY INSTRUCTIONS:

* These instructions are provided for your safety.

* It is very important that they are read completely before beginning the installation of your ﬁ xture.

* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.

* Turn off power at switch before replacing bulbs, making sure ﬁ xture has had sufﬁ cient time to cool down.

ASSEMBLY INSTRUCTIONS:

1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT BREAKER.

2. Remove all parts from carton and discard packing materials. Place the parts on a level surface.

3. Remove mounting plate (A) from backplate (B) by unthreading decorative nuts (C). Set decorative nuts (C) aside.

4. Carefully pull wires from the wall outlet box and thread them through the center hole in mounting plate (A).

5. Afﬁ x mounting plate (A) to wall outlet box with mounting screws (D) provided.

6. Lift the ﬁ xture to the mounting plate and make the proper electrical connections noted in steps 7 through 9.

A LICENSED ELECTRICIAN IS RECOMMENDED.

7. Attach ground wire from ﬁ xture (green or copper in color) to ground wire from outlet box. Fasten wires together with wire nut (J)

and tightly wrap connection with electrical tape.

8. Attach hot wire from ﬁ xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire

nut (J) and tightly wrap connection with electrical tape.

9. Attach neutral wire from ﬁ xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with

wire nut (J) and tightly wrap connection with electrical tape. Gently push wire connections back into the wall outlet box.

10. Place backplate (B) over mounting plate (A). Threaded tube (E) should ﬁ t through the holes in the backplate. Thread decorative nuts (C) onto

exposed threading (E) to secure backplate to the mounting plate. Turn decorative nuts (C) until hand tight.

11. Install one 40W MAX. Type B, candelabra base bulb into the socket.

12. Remove decorative nuts (H) from threaded tube (F).

13. Place shade (I) over backplate (B). Threading (F) from the backplate should ﬁ t through the holes (G) in the shade (I). Thread

decorative nuts (H) onto exposed threading (F) to secure shade to the backplate. Turn decorative nuts (H) until hand tight.

14. Reconnect main electrical supply at the fuse box/ circuit breaker and test the ﬁ xture.

** To clean, use soft cloth only. Do not use any chemical or abrasive cleaners. **

(J )

(D)

(A)

(B)

(C)

(I)

(H)

(G)

(F)

(E)