Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
OVO FLOOR
LAMP
2045
1. Carefully remove all parts from carton.
2. Place lamp base (K) on level surface.
3. Carefully thread column (J) onto base (K).
4. Carefully thread column (H) into column (J). NOTE: Pull
cord from below base when threading parts together to
prevent damage to wire.
4. Remove ange (A) from threaded socket (F).
5. Place plastic washer (E) onto socket cup (G), letting socket
(F) pass through hole in center of plastic washer (E).
6. Place glass shade (D) on top of socket cup (G). Threaded
socket (F) will pass through center hole in shade spider.
7. Place plastic washer (C) and metal washer (B) over threaded
socket (F).
8. To secure shade (D) to lamp, thread plastic ange (A) onto
exposed portion of threaded socket (F).
9. Insert one (1) 150W MAX. Type A, medium base bulb into
socket (F).
10. Remove protective plastic (L) from polarized plug (M).
11. Insert polarized plug (M) into wall outlet.
12. Use knob (I) to control power to lamp. NOTE: This lamp
uses a full range dimmer switch. Each switch will stop
turning once full illumination is reached. Turn the switch
GENTLY to adjust light intensity. TURNING KNOB (H)
TOO FAR COULD CAUSE THE SWITCH TO SHORT
OUT.
To clean, wipe with a soft cloth only. Do not use any chemicals
or abrasive cleaners as they may damage the nish.
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(L)
(M)
(H)
(I)
(J)
(K)
IMPORTANT SAFETY INSTRUCTIONS
*Turn the power off (remove electrical plug from wall outlet) before
replacing light bulb, making sure the bulb has had sufcient time to
cool down. Do not subject the lamp to any shock while lit as
shattering of bulb may result.
*This portable lamp has a polarized plug (one blade is wider than the
other) as a feature to reduce risk of electric shock. This plug will t
in a polarized outlet only one way. If it does not t fully in the outlet,
reverse the plug. If it still does not t, contact a qualied electrician.
Never use with an extension cord unless the plug can be fully inserted.
*DO NOT ALTER THE PLUG.
ASSEMBLY INSTRUCTIONS