Installation Guide

COLE OVAL CHANDELIER
3343
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It’s important that all safety instructions are read before
beginning installation of xture.
*We STRONGLY recommend installation by a licensed electrician.
*Do not connect the electricity until lamp is fully assembled.
*If any special control devices are used with this xture, follow the instructions carefully to assure full
compliance with N.E.C. requirements. If there are any questions, contact a qualied electrical contractor.
*This xture is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS FOR YOUR
Page 1 of 2
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing materials. Place the parts on a protected work surface.
3. Remove mounting plate (A) from canopy (E) by removing screws (D). Set screws (D) aside.
4. Place the mounting plate (A) against the mounting surface so it is aligned with the ceiling outlet box. Once
aligned, check to make sure that the position of the mounting plate is straight. When the proper placement has
been conrmed, use a pencil to mark the locations of the mounting plate support holes (B) onto the mounting
surface.
5. Set the mounting plate aside and drill small holes at the marked locations. Holes should be sized so anchors
(M), provided, t securely inside. Push anchors (M) into holes.
6. Carefully pull the wiring from the ceiling outlet box. Thread the wires through the center hole in mounting
plate (A).
7. Ax mounting plate (A) to outlet box with mounting screws (C) provided.
8. For additional support, thread mounting screws (N) through holes (B) and into wall anchors (M).
9. Measure desired drop for xture to hang and add/remove chain links (H) with chain break tool (not
included).
10. Secure quick link (G) to hang straight (F). Repeat this step for the other chain.
11. Guide wire exiting the xture through the chain (H), quick link (G), through the center of the hang straight
(F), and up through the hole in the canopy (E).
12. Cut the cord to the desired length to make electrical connections.
13. Lift canopy (E) to mounting plate (A) and make proper electrical connections described in steps 14-16. A
LICENSED ELECTRICIN IS RECOMMENDED.
14. Attach ground wire from the xture (green or copper in color) to the ground wire in outlet box. Fasten wires
together with wire nut (O) and tightly wrap connection with electical tape.
15. Attach hot wire from xture (black in color, or smooth side of wire) to hot wire from ceiling outlet box.
Fasten wires together with wire nut (O) and tightly wrap connection with electrical tape.
16. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from ceiling outlet
box. Fasten wires together with wire nut (O) and tightly wrap connection with electrical tape.
17. Gently push wire conections back into ceiling outlet box. Slide canopy (E) over mounting plate (A). Thread
screws (D) into holes in canopy (E) to secure xture to ceiling.
18. Install ve 60W MAX. Type B candelabra base bulbs into the sockets (K).
19. Insert glass rod (I) into top housing (J). Gently slide glass rod until it sits securely in bottom housing (L).
Repeat for remaining glass rods.
20. Reconnect main electrical supply at the fuse box/circuit breaker and test xture.