Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
TRIGGER CHANDELIER
14. Slide canopy (D) up extensions (I) and hold fl ush against ceiling. To secure position of canopy (D), slide collar (E) up
extensions (I) and thread onto hang straight (F). Turn until hand tight.
15. Remove fl ange (L) from socket (M). Place shade (K) onto socket (M). Thread fl ange (L) back onto socket (M) to secure
shade to fi xture. Repeat step for remaining shades.
16. Install eight 60W max Type B, candelabra base bulbs into sockets (M).
17. Reconnect main electrical supply from the fuse box/ circuit breaker and test the fi xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE
BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove quick link (G) from hang straight (F). Keep quick
link (G) attached to loop (H).
4. Remove cross bar (A) (with threaded nipple (C) and hang
straight (F) attached) from canopy (D) by unscrewing collar
(E). Affi x cross bar (A) to ceiling outlet box using screws
(B) provided.
5. Carefully slide threaded collar (E) down extensions (I) until
it rests on housing (J). Slide canopy (D) down extensions (I)
so it rests on collar (E).
6. Measure desired drop for fi xture to hang and add/remove
extension tubes (I) to reach desired height. Guide wiring
through extension tube before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the
threaded nipple of one extension out of/into the threaded
opening of the next extension. Make sure to pull cord tight
when threading parts together to prevent damage to wire.**
7. Thread bottom extension tube (I) onto housing (J).
8. Lift fi xture to ceiling and secure quick link (G) to hang
straight (F). Carefully guide wire through hang straight (F)
and threaded nipple (C) into ceiling outlet box.
9. Make proper electrical connections noted in steps 10-12. A
LICENSED ELECTRICIAN IS RECOMMENDED.
10. Attach ground wire from fi xture (green or silver in color) to
ground wire from outlet box. Fasten wires together with
wire nut (N). Tightly wrap connection with electrical tape.
11. Attach hot wire from fi xture (black in color or smooth side
of wire) to hot wire from outlet box. Fasten wires together
with wire nut (N) and wrap connection with electrical tape.
12. Attach neutral wire from fi xture (white in color or ribbed
side of wire) to neutral wire from outlet box. Fasten wires
together with wire nut (N) and tightly wrap connection with
electrical tape.
13. Carefully push wires back into ceiling outlet box.
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It is very important that they are read completely before beginning installation.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn off power at switch before replacing bulb, making sure fi xture has had suffi cient time to cool down.
* If any special control devices are used with this fi xture, follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualifi ed electrical contractor.
3396
(A)
(B)
(C)
(N)
(F)
(E)
(D)
(G)
(H)
(I)
(I)
(L)
(K)
(M)
(I)
(J)
(I)