Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
4500
12. Attach neutral wire(s) from fi xture (white in color or ribbed side of
wire) to neutral wire from outlet box. Fasten wires together with
wire nut (A) and tightly wrap connection with electrical tape.
13. Carefully push wire connections back into ceiling outlet box.
14. Slide canopy (I) up extensions (H) and hold fi rmly against ceiling.
Slide collar (J) up extensions (H) and thread onto hang straight (E)
to secure canopy (I) against the ceiling.
15. Install eight 60W MAX. Type B, candelabra base bulbs into the
sockets.
16. Reconnect main electrical supply at the fuse box/circuit breaker
and test the fi xture.
** To clean, use soft cloth only. Do not use any chemical or
abrasive cleaners as they can damage the fi nish.**
(A)
(B)
(D)
(H)
(H)
(H)
(H)
(C)
(E)
(F)
(G)
(I)
(J )
(K)
(L)
delany round chandelier
ASSEMBLY INSTRUCTIONS
**SHUT OFF ELECTRICAL SUPPLY AT CIRCUIT BREAKER**
1. Remove all parts carefully from the carton. Do not throw away any parts.
2. Remove cross bar (B) from hang straight (E) by unthreading tube (C) from hang
straight (E). Affi x cross bar (B), including threaded tube (C), to ceiling outlet
box using mounting screws (D) provided.
3. Measure desired drop for fi xture to hang and add/remove extension tubes (H)
as needed. Guide wiring through extensions before threading tubes together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded nipple of one
extension into/ out of the threaded opening of the next extension. Make sure
electrical cord is pulled tight when threading extensions together to prevent
damage to the wiring.**
4. Thread the bottom extension (H) onto the threaded tube located at the top of
housing (K).
5. Guide wiring from top extension (H) through center hole in hang straight (E).
6. Unthread collar (J) from hang straight (E). Slide collar (J) and canopy (I) down
extensions (H) until they rest on housing (K).
7. Lift fi xture to ceiling outlet box. Guide wiring through threaded tube (C). Thread
hang straight (E) onto threaded tube (C).
8. Connect loop (G) and hang straight (E) using quick link (F).
9. Pull wiring from ceiling outlet box and make proper electrical connections
described in steps 10-12. A LICENSED ELECTRICIAN IS RECOMMENDED.
Note: The wires for the down light (L) are the individual black and white wires.
The down light (L) can be wired separately from the rest of the fi xture if you
wish. The clear cord contains the wiring for the remaining eight bulbs.
10. Attach ground wire from fi xture (green or silver in color) to ground wire from
outlet box. Fasten wires together with wire nut (A) and tightly wrap connection
with electrical tape.
11. Attach hot wire(s) from fi xture (black in color or smooth side of wire to hot
wire from outlet box. Fasten wires together with wire nut (A) and tightly wrap
connection with electrical tape.
IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is important that they are read completely before beginning installation of fi xture.
*Turn off power at switch before replacing bulbs.
*If any special control devices are used with this fi xture, follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualifi ed electrical contractor.
*WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.