Installation Guide

554
ASSEMBLY INSTRUCTIONS FOR YOUR
(L)
(M)
(K)
(A)
(B)
(C)
(D)
(E)
(G)
(H)
(F)
(I)
(J)
BOND CHANDELIER
12. Secure quick link (G) to hang straight (F). Repeat this step for remaining extension set.
13. Guide wire exiting the xture through the extensions (H), quick link (G), through the center of the hang straight (F), and up through the hole in
the canopy (D).
14. Cut the cord to the desired length to make electrical connections.
15. Lift canopy (D) to mounting plate (A) and make proper electrical connections described in steps 16-18. A LICENSED ELECTRICIN IS
RECOMMENDED.
16. Attach ground wire from the xture (green or copper in color) to the ground wire in outlet box. Fasten wires together with wire nut (M) and
tightly wrap connection with electical tape.
17. Attach hot wire from xture (black in color, or smooth side of wire) to hot wire from ceiling outlet box. Fasten wires together with wire nut (M)
and tightly wrap connection with electrical tape.
18. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from ceiling outlet box. Fasten wires together with wire nut
(M) and tightly wrap connection with electrical tape.
19. Gently push wire conections back into ceiling outlet box. Slide canopy (D) over mounting plate (A). Thread screws (E) into holes in canopy (D)
to secure xture to ceiling.
20. Install seven 60W MAX. Type B candelabra base bulbs into the sockets.
21. Reconnect main electrical supply at the fuse box/circuit breaker and test xture.
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It’s important that all
safety instructions are read before beginning installation of xture.
* We STRONGLY recommend installation by a licensed electrician.
* Do not connect the electricity until lamp is fully assembled.
* If any special control devices are used with this xture, follow the
instructions carefully to assure full commpliance with N.E.C.
requirements. If there are any questions, contact a qualied electrical
contractor.
* This xture is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER.
2. Remove all parts from carton and discard packing materials. Place the
parts on a protected work surface.
3. Remove mounting plate (A) from canopy (D) by removing screws
(E). Set screws (E) aside.
4. Place the mounting plate (A) against the mounting surface so it is
aligned with the ceiling outlet box. Once aligned, check to make sure
that the position of the mounting plate is straight. When the proper
placement has been conrmed, use a pencil to mark the locations of
the mounting plate support holes (B) onto the mounting surface.
5. Set the mounting plate aside and drill small holes at the marked
locations. Holes should be sized so anchors (L), provided, t securely
inside.
6. Push anchors (L) into holes.
7. Carefully pull the wiring from the ceiling outlet box. Thread the wires
through the center hole in mounting plate (A).
8. Ax mounting plate (A) to outlet box with mounting screws (C)
provided.
9. For additional support, thread mounting screws (K) through holes (B)
and into wall anchors (L).
10. Measure desired drop for xture to hang and add/remove extension
tubes (I).
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the threaded
tube of one extension out of/into the threaded opening of the next
extension. Make sure wiring is pulled tight when threading
extensions together to prevent damage to the wire.**
11. Thread bottom extension (I) on to threaded tube (J). Repeat step for
other set of extensions.
*** To clean, use a soft dry cloth. Do not use any chemical or abrasive cleaners.***