Installation Guide

ASSEMBLY INSTRUCTIONS FOR YOUR
VENTANA
2-TIER CHANDELIER
673
ASSEMBLY INSTRUCTIONS:
WARNING:
*Turn the power to xture off before replacing bulbs, making sure the bulbs have had sufcient
time to cool down. Do not subject the xture to any shock while lit as shattering of bulbs may
result.
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/ CIRCUIT
BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Remove cross bar (A) from threaded nipple (D), and canopy (C). Afx cross bar (A) to “J BOX”
using screws (B) provided.
4. Remove quick connector (E) from loop on threaded nipple (D) and loop on top extension (F).
5. Measure desired drop for xture to hang and add / remove extension tubes (F). Guide wiring
through extension tubes before threading tubes together.
**ADD / REMOVE EXTENSIONS: (Un)Thread the threaded nipple of one extension into the
threaded opening of the next extension. Make sure wiring is pulled tight when threading
extensions together to prevent damage to the wire**
6. Thread wiring through threaded nipple (D).
7. Thread wiring through canopy (C).
8. Lift xture to “J BOX”, and thread wiring through hole in crossbar (A) Make proper electrical
connection. A LICENSED ELECTRICIAN IS RECOMMENDED.
9. Connect the ground wire (green or copper) from the xture to the ground wire in the outlet box.
Connect the black wire of the xture (or smooth side of the wire) to the black wire in outlet
box using wire nut (I). Tightly wrap connection with electrical tape. Connect the white wire
of the xture (or rough side of the wire) to the white wire in outlet box using wire nut (I).
Tightly wrap connection with electrical tape.
10. Hold canopy against ceiling over “J BOX”. Slide threaded nipple (D) through canopy (C)
and thread into hole in center of crossbar (A). Turn until collar on threaded nipple (D) holds
canopy securely against ceiling.
11. Attach quick connector (E) to loop on threaded nipple (D) and loop on top extension (F).
12. Install eight (8) B9.5 Candelabra 25W max bulbs into sockets (H).
13. To attach shades (G) to xture, open shade clip (located inside shade (G)) and slide clip over
bulb until clip reaches a resting position. (DO NOT ATTACH SHADES UNLESS POWER TO
FIXTURE IS OFF.)
 












IMPORTANT SAFETY INSTRUCTIONS:
*These instructions are provided for your safety. It is very important that they are read completely
before beginning the installation of your xture.
*DIRECT WIRE FIXTURES: WE STRONGLY RECOMMEND INSTALLATION BY A
LICENSED ELECTRICIAN.
CARE INSTRUCTIONS:
*To clean, use a soft cloth only. DO NOT use any chemical or abrasive cleaners.