Installation Guide

410
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton. Do not throw away any parts.
3. Pull cord taut from above and thread bottom extension (J) onto nipple exiting housing (K).
4. Remove quick link (G) from hang straight (F). Keep quick link (G) attached to chain (H).
5. Remove cross bar (A) (with threaded nipple (C) and hang straight (F) attached) from canopy (D). Do this by unthreading collar (E)
from hang straight (F). Canopy (D) will slip over hang straight (F). Set the canopy (D) and collar (E) aside.
6. Afx cross bar (A) (with threaded nipple (C) and hang straight (F) attached) to ceiling outlet box using screws (B) provided.
7. Measure desired drop for xture to hang and add/remove chain links (H) with chain break tool (not included).
8. Attach quick link (I) to extension loop (J).
9. Slip collar (E) over chain (H) so it rests on loop (J). Slip canopy (D) over chain (H) so it also rests on loop (J).
10. Lift xture to ceiling and secure quick link (G) to hang straight (F). Guide the wire exiting the xture through the center of
collar (E) and canopy (D). Continue to guide the wire through chain (H), quick link (G) and through the center of hang straight
(F) and threaded nipple (C).
11. Make proper electrical connections described in steps 12 - 14. A LICENSED ELECTRICIAN IS RECOMMENDED.
12. Attach ground wire from xture (green or silver in color) to ground wire from outlet box. Fasten wires together with wire nut (P)
and tightly wrap connection with electrical tape.
13. Attach hot wire from xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire
nut (P) and tightly wrap connection with electrical tape.
14. Attach neutral wire from xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with
wire nut (P) and tightly wrap connection with electrical tape.
15. Carefully push wire connections back into ceiling outlet box.
16. Slide canopy (D) up chain (H) and hold ush against ceiling. To secure position of canopy (D), slide collar (E) up the chain and
thread it onto hang straight (F). Turn until hand tight.
17. Remove ange (M) and spacer (N) from socket (O). Carefully slide glass shade (L) onto socket (O).
18. Slide spacer (N) over socket (O). Thread ange (M) onto socket (O) until hand tight to secure spacer and shade. Repeat steps
17-19 for remaining shades.
19. Install six 100W MAX. Type A, medium base bulbs into the sockets.
20. Reconnect main electrical supply from the fuse box/ circuit breaker and test the xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It is very important that they are read completely before beginning the installation
of your xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn off power at switch before replacing bulbs, making sure xture has had sufcient time to cool down.
* If any special control devices are used with this xture, follow the instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualied electrical contractor.
ASSEMBLY INSTRUCTIONS FOR YOUR
WILLIAMSBURG TYRIE CHANDELIER